Ashdown Fallen Angel 50 DSP Combo 사용 설명서 - 페이지 8

{카테고리_이름} Ashdown Fallen Angel 50 DSP Combo에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashdown Fallen Angel 50 DSP Combo 11 페이지. Combo & head

페이지 인쇄

FUSED MAINS INLET SOCKET - This is for

connection to your countries mains supply

using the appropriate mains cable supplied.

Always use a mains outlet that has an earth

or ground connection for safety. Never

remove or replace the plug on the supplied

cable. Always replace the fuse with the same

type and rating as stipulated on the rear

panel adjacent to the mains inlet socket.

FOOTSWITCH SOCKETS - There are 3

footswitch sockets provided on this amplifier.

For any of these footswitch sockets to

operate it is essential that the corresponding

front panel push buttons be in the OUT

position. The first of these sockets is a mono

jack for connection of the supplied, special 4

way footswitch. Always connect this prior to

turning on the power to the amplifier as this

derives its power from the amplifier and

sends a serial data stream to the amplifier to

operate the various functions. The next 2 x

footswitch sockets are both stereo sockets

and use a standard 2 way, push on push off

type footswitch for their operation. These

may be used as an alternative to the

dedicated 4 way footswitch supplied.

EFFECTS LOOP - The EFFECTS LOOP on these

amplifiers is a Serial loop. This has jack

sockets for Effects Send & Effects Return

signals; the Effects return socket also has an

Effects Return Level control associated with it

for adjusting the level of the returned signal.

SPEAKER EMULATED LINE OUTPUT - The

FA50 & FA 100 amplifiers have a special

Speaker Emulated Line Output jack socket

that can be used for direct recording the

guitar sound. This has a special Equalisation

circuit that Emulates the characteristics of the

loudspeaker/Output stage combination.

SPEAKER OUTPUT SOCKETS

INTERNAL SPEAKER 8 OHMS - This is the

socket for connection to the internal 8 Ohm

speaker for a combo amplifier.

Rear Panel Facilities

EXTERNAL SPEAKER 8 OHMS - This is an

external speaker socket for connecting to an

8 Ohm speaker such as a 2 x 12 cabinet

(normally 8 Ohms). This socket is in parallel

with the internal speaker socket, so if an

external 8 Ohm speaker is used with the

internal speaker still connected then the

combined impedance will be 4 Ohms.