Ashdown Fallen Angel 50 DSP Combo Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz do instrumentów muzycznych Ashdown Fallen Angel 50 DSP Combo. Ashdown Fallen Angel 50 DSP Combo 11 stron. Combo & head
Drukuj stronęFUSED MAINS INLET SOCKET - This is for
connection to your countries mains supply
using the appropriate mains cable supplied.
Always use a mains outlet that has an earth
or ground connection for safety. Never
remove or replace the plug on the supplied
cable. Always replace the fuse with the same
type and rating as stipulated on the rear
panel adjacent to the mains inlet socket.
FOOTSWITCH SOCKETS - There are 3
footswitch sockets provided on this amplifier.
For any of these footswitch sockets to
operate it is essential that the corresponding
front panel push buttons be in the OUT
position. The first of these sockets is a mono
jack for connection of the supplied, special 4
way footswitch. Always connect this prior to
turning on the power to the amplifier as this
derives its power from the amplifier and
sends a serial data stream to the amplifier to
operate the various functions. The next 2 x
footswitch sockets are both stereo sockets
and use a standard 2 way, push on push off
type footswitch for their operation. These
may be used as an alternative to the
dedicated 4 way footswitch supplied.
EFFECTS LOOP - The EFFECTS LOOP on these
amplifiers is a Serial loop. This has jack
sockets for Effects Send & Effects Return
signals; the Effects return socket also has an
Effects Return Level control associated with it
for adjusting the level of the returned signal.
SPEAKER EMULATED LINE OUTPUT - The
FA50 & FA 100 amplifiers have a special
Speaker Emulated Line Output jack socket
that can be used for direct recording the
guitar sound. This has a special Equalisation
circuit that Emulates the characteristics of the
loudspeaker/Output stage combination.
SPEAKER OUTPUT SOCKETS
INTERNAL SPEAKER 8 OHMS - This is the
socket for connection to the internal 8 Ohm
speaker for a combo amplifier.
Rear Panel Facilities
EXTERNAL SPEAKER 8 OHMS - This is an
external speaker socket for connecting to an
8 Ohm speaker such as a 2 x 12 cabinet
(normally 8 Ohms). This socket is in parallel
with the internal speaker socket, so if an
external 8 Ohm speaker is used with the
internal speaker still connected then the
combined impedance will be 4 Ohms.