CYP PUV-2000RX 운영 매뉴얼 - 페이지 7

{카테고리_이름} CYP PUV-2000RX에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP PUV-2000RX 16 페이지. Hdmi/audio over cat5e/6/7 extender with 48v poe

6. OPERATION CONTROLS AND FUNCTIONS

DC 48V POWER AUDIO IN

−

DC 48V and POWER LED: Plug the 48V DC power supply into the

unit and connect the adaptor to an AC outlet and the LED will

illuminate.

AUDIO IN L/R: Connect with audio source equipment such as PC

or CD player for audio signal sending to Receiver's AUDIO OUT L/R.

IR IN 2: Connect to the supplied IR Extender cable for IR signal

reception. Ensure that remote being used is within the direct line-

of-sight of the IR Extender.

IR OUT 1: Connect to the supplied IR Blaster Cable for IR signal

transmission. Place the IR Blaster in direct line-of-sight of the

equipment to be controlled.

RS-232 IN TX/RX: Connect to a PC or Laptop with 3-pin Relay cable

for the transmission of RS-232 commands. For receiving command

from Receiver side, the TX and Rx pin must be reversed.

UPDATE: This is reserved for ﬁ rmware update use only. Switch

this deep switch to left for ﬁ rmware update use, under normal

operation, leave the switch on right. Update procedure may be

done from the same RS-232 port for both Transmitter and Receiver.

IR IN2 IR OUT1

RS-232 IN

UPDATE