CYP PUV-2000RX 운영 매뉴얼 - 페이지 9

{카테고리_이름} CYP PUV-2000RX에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP PUV-2000RX 16 페이지. Hdmi/audio over cat5e/6/7 extender with 48v poe

6.3 Receiver Front Panel

POWER AUDIO OUT IR IN1 IR OUT2

POWER LED: This LED will illuminate when device is connected with

power supply.

AUDIO OUT L/R: Connect to speaker with RCA input for audio

signal output.

IR IN 1: Connect to the supplied IR Extender cable for IR signal

reception. Ensure that remote being used is within the direct line-

of-sight of the IR Extender.

IR OUT 2: Connect to the supplied IR Blaster cable for IR signal

transmission. Place the IR Blaster in direct line-of-sight of the

equipment to be controlled.

RS-232 OUT TX/RX: Connect to the device that is to be controlled

via 3-pin Relay cable by RS-232 commands. For sending command

to Transmitter side, the TX and Rx pin must be reversed.

UPDATE: This is reserved for ﬁ rmware update use only. Switch

this deep switch to left for ﬁ rmware update use, under normal

operation, leave the switch on right. Update procedure may be

done from the same RS-232 port for both Transmitter and Receiver.

RS-232 OUT

UPDATE