Cloud CV8125 빠른 시작 매뉴얼 - 페이지 11
{카테고리_이름} Cloud CV8125에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cloud CV8125 13 페이지. Cv series
Cloud CV8125에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지), 기술 게시판 (13 페이지)
페이지 인쇄
Using the Auxiliary Outputs
The two rear panel connectors AUX 1 and AUX 2 may be used to drive additional amplifiers, for recording, or any other purpose
where system "expansion" is required. The connectors are 3-pin, 3.5 mm-pitch screw terminal type.
The signals at the auxiliary outputs are balanced and line level, and can thus be use to drive most external equipment directly.
The connector pinout is identical to that used for the amplifier inputs:
The factory default sources for outputs AUX 1 and AUX 2 are the signals routed to the inputs of Channels 1 and 2 respectively.
It can be seen from the Input Routing examples from page 9 that in practice this means that AUX 1 will always carry the
signal applied to INPUT 1, and AUX 2 will always carry the signal selected by INPUT ROUTING DIP switch 2 - either that
applied to INPUT 1 or that applied to INPUT 2.
Note also that the sources for the auxiliary outputs are effectively derived "post" the rear panel channel (the factory default
setting) preset controls, and thus the LEVEL controls for Channels 1 and 2 will vary the output level at AUX 1 and AUX 2
respectively.
1
2
3
scn
hot (+)
cold (-)
OUTPUT: BALANCED
CONNECTION
(DON'T CONNECT PIN 2)
1
2
3
hot (+)
scn
OUTPUT: UNBALANCED
CONNECTION
CV Series Digital Amplifiers v1.0
11