Cloud CV8125 Посібник із швидкого старту - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Блок управління Cloud CV8125. Cloud CV8125 13 сторінок. Cv series
Також для Cloud CV8125: Посібник (15 сторінок), Технічний бюлетень (13 сторінок)
Друкувати сторінку
Using the Auxiliary Outputs
The two rear panel connectors AUX 1 and AUX 2 may be used to drive additional amplifiers, for recording, or any other purpose
where system "expansion" is required. The connectors are 3-pin, 3.5 mm-pitch screw terminal type.
The signals at the auxiliary outputs are balanced and line level, and can thus be use to drive most external equipment directly.
The connector pinout is identical to that used for the amplifier inputs:
The factory default sources for outputs AUX 1 and AUX 2 are the signals routed to the inputs of Channels 1 and 2 respectively.
It can be seen from the Input Routing examples from page 9 that in practice this means that AUX 1 will always carry the
signal applied to INPUT 1, and AUX 2 will always carry the signal selected by INPUT ROUTING DIP switch 2 - either that
applied to INPUT 1 or that applied to INPUT 2.
Note also that the sources for the auxiliary outputs are effectively derived "post" the rear panel channel (the factory default
setting) preset controls, and thus the LEVEL controls for Channels 1 and 2 will vary the output level at AUX 1 and AUX 2
respectively.
1
2
3
scn
hot (+)
cold (-)
OUTPUT: BALANCED
CONNECTION
(DON'T CONNECT PIN 2)
1
2
3
hot (+)
scn
OUTPUT: UNBALANCED
CONNECTION
CV Series Digital Amplifiers v1.0
11