Ashly MX-206 운영 매뉴얼 - 페이지 4
{카테고리_이름} Ashly MX-206에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly MX-206 12 페이지. Stereo microphone mixer
Ashly MX-206에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지), 기술 노트 및 사양 (2 페이지), 운영 매뉴얼 (8 페이지), 운영 매뉴얼 (9 페이지)
페이지 인쇄Operating Manual -MX-206 Stereo Microphone Mixer
2
Clip
4.5 Stereo Aux Input
This control adjusts the level of the stereo signal
from the RCA inputs on the back panel. The Tape/CD
input should have a nominal level of -10dB.
4.6 Stereo Outputs
The Left and Right output levels are
independantly controlled by these two dials. They re-
spectively determine the signal at the 1/4" jack Main out-
puts.
4.7 Mono Output
This inner concentric control determines the out-
put level of the transformer-balanced Mono Output XLR
connector. Its signal is summed from the right and left
mix bus, and is fully independant of the settings of the
stereo output level controls.
4.8 Headphones Output Level
This outer concentric control determines the level
of the stereo headphones, and is fully independant of the
settings of the stereo and mono output level controls
4.9 Output Meters
Two 6-segment LED arrays show the current sta-
tus of the stereo outputs. 0VU is equivalent to +4dBu
(1.228Vrms).
4.10 Stereo Headphone Jack
You can monitor the stereo mix through head-
phones independant of all other output controls. In other
words, the headphones can be used even if all other out-
put controls are turned off.
4.11 Phantom Power Indicator
This red LED is lit when the +48V phantom
power is turned on. The phantom power switch is on the
back panel.
Model MX-206
Made In USA
4
Ch.1
Ch.2
5
4
6
4
3
7
3
8
2
Input
1
1
Clip
(dB)
L
R
L
0
10
0
-20
-40
-60
Level
Pan
Level
100-120VAC
50-60Hz 15W
Ch.3
5
5
6
4
6
7
3
8
2
Input
1
Clip
(dB)
R
L
R
10
0
10
-20
-40
-60
-20
Pan
Level
Pan
4.12 Power Switch
This switch turns on AC power to the mixer, light-
ing the green LED. If the switch is pressed but the LED
is still off, check to see that the AC power cord is not
detached.
5. CONNECTIONS AND CABLES
The MX-206 mixer is fitted with four types of
audio connectors: 3-pin XLR type male (mono output),
3-pin XLR type female (mic inputs), tip-ring-sleeve (TRS)
phone jacks, and RCA jack. Although using unbalanced
tip-sleeve 1/4" plugs will work in certain applications,
we recommend always using balanced TRS cabling for
the stereo 1/4" jack outputs.
Stereo
Outputs
Phantom
Right
Left
Pwr.
Ch.4
5
4
6
7
3
7
8
2
8
Input
Input
1
Clip
(dB)
(dB)
L
R
0
10
-40
-60
-20
-40
Level
Pan
Mono Output
3
1
2
(-) (+)
Transformer
Balanced
Ch.5
5
4
6
3
7
2
8
Inpu
1
Clip
(dB
L
R
0
10
-60
-20
-40
Level
Pan
Stereo Aux
-L-
-R-
Aux
Aux
Out
In