Ashly FR-16 운영 매뉴얼 - 페이지 5
{카테고리_이름} Ashly FR-16에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly FR-16 17 페이지. Fr remotes network remote controls
Ashly FR-16에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지), 제품 사양 (2 페이지)
페이지 인쇄Operating Manual - FR-8 and FR-16 Remote Level Controller
Mechanical Installation
The FR-8 and FR-16 are designed to be mounted to an electrical wall box or modular box array,
to any flat surface using the provided cutout, to a custom Ashly rack mounting kit (sold separately),
or as a freestanding desktop controller.
The FR-16 will mount to a modular 7-gang US electrical box, with a minimum box depth of
2.25". The FR-8 mounts to a 4-gang electrical box. For mounting to a wall or flat surface without
using a wall box, a mechanical drawing and cutout pattern are provided in this manual on pages 9.
Fader and switch function labels can be created using the document template found on the
Ashly website and referenced in this manual on page 10.
Follow these instructions for mounting to an electrical wall box, rack kit, or surface:
Note: Remove power
before mounting. Avoid
static shock disruptions
to this or other connected
devices by mounting to an
earth-grounded metal wall
box or other earth grounded
point. This prevents static
discharge from flowing
through the data lines.
1) Remove Front Panel Using These Eight (four on FR-8) Screws.
2) Insert Fader and Switch Labels Beneath Front Panel Overlay.
3) Remove Ribbon Cable as Shown Below.
4) Prepare Electrical Box, Panel Cutout, or Rack Mounting Kit,
and Install Wiring.
5) Plug In Ethernet Cable and Lockout Wiring Before Mounting.
6) Fasten the FR Rear Panel to Wall, Wall Box, Rack Mounting Kit,
or Other Flat surface Using These Four Holes.
7) Re-Insert Ribbon Cable As Shown Below and Replace Front Panel.
(3) Remove ribbon cable by pushing
apart the two cable ejector levers.
Do NOT pull on ribbon cable!
(7) Re-Insert ribbon cable by pushing
in the cable header back into socket.
Ejector pins will automatically
snap back to locked position.
5