Ashly FR-16 Kullanım Kılavuzu - Sayfa 5

Uzaktan Kumanda Ashly FR-16 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Ashly FR-16 17 sayfaları. Fr remotes network remote controls
Ayrıca Ashly FR-16 için: Kullanım Kılavuzu (12 sayfalar), Ürün Özellikleri (2 sayfalar)

Sayfayı Yazdır

Operating Manual - FR-8 and FR-16 Remote Level Controller

Mechanical Installation

The FR-8 and FR-16 are designed to be mounted to an electrical wall box or modular box array,

to any flat surface using the provided cutout, to a custom Ashly rack mounting kit (sold separately),

or as a freestanding desktop controller.

The FR-16 will mount to a modular 7-gang US electrical box, with a minimum box depth of

2.25". The FR-8 mounts to a 4-gang electrical box. For mounting to a wall or flat surface without

using a wall box, a mechanical drawing and cutout pattern are provided in this manual on pages 9.

Fader and switch function labels can be created using the document template found on the

Ashly website and referenced in this manual on page 10.

Follow these instructions for mounting to an electrical wall box, rack kit, or surface:

Note: Remove power

before mounting. Avoid

static shock disruptions

to this or other connected

devices by mounting to an

earth-grounded metal wall

box or other earth grounded

point. This prevents static

discharge from flowing

through the data lines.

1) Remove Front Panel Using These Eight (four on FR-8) Screws.

2) Insert Fader and Switch Labels Beneath Front Panel Overlay.

3) Remove Ribbon Cable as Shown Below.

4) Prepare Electrical Box, Panel Cutout, or Rack Mounting Kit,

and Install Wiring.

5) Plug In Ethernet Cable and Lockout Wiring Before Mounting.

6) Fasten the FR Rear Panel to Wall, Wall Box, Rack Mounting Kit,

or Other Flat surface Using These Four Holes.

7) Re-Insert Ribbon Cable As Shown Below and Replace Front Panel.

(3) Remove ribbon cable by pushing

apart the two cable ejector levers.

Do NOT pull on ribbon cable!

(7) Re-Insert ribbon cable by pushing

in the cable header back into socket.

Ejector pins will automatically

snap back to locked position.