Ashly FR-8 운영 매뉴얼 - 페이지 5

{카테고리_이름} Ashly FR-8에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly FR-8 12 페이지. Fr remotes network remote controls
Ashly FR-8에 대해서도 마찬가지입니다: 운영 매뉴얼 (17 페이지), 제품 사양 (2 페이지)

페이지 인쇄

Operating Manual - FR-8 and FR-16 Remote Level Controller

4.1 Software - FR Control Surface Features

Within the main FR-8 or FR-16 control surface, there are two tabs at the bottom labeled

"Configuration" and "Fader Test". All device targeting and programming of faders happens in the

configuration tab. There are no user controls in the fader test tab, it is meant only for visual refer-

ence, indicating current FR fader and switch position as well as front panel lockout status.

Global Features:

Device Name:

in the device menu tree in the Protea

Target Security:

= "default" with no password), the FR device will have full access to all available control parameters

on the targeted DSP device. However, if an administrator wishes to limit control parameter access from

an FR controller to selected target devices on the network, they must enter the same user name and

password on both the FR-8/16 target security fields and on the specified target's device users section,

under the general security tab. Think of it as creating a login requirement for each device before they

can be assigned to work together, up to the level of parameter access granted by the target device. Note

that even though "Default" and "Admin" are reserved system user names, any changes to these reserved

FR name or password fields requires a corresponding entry on the target device. Note also that target

security is completely independent from the general FR security section described in section 5, and that

user names and passwords implemented there have no impact to or from those used for target security.

Global features affect the entire FR device and include the following:

Up to 20 characters can be used for the device name. The name appears

Software startup screen, as well as the main FR device screen.

When target security is left unspecified or in its default state (user name