ASI 0391-1AC 설치 및 유지 관리 매뉴얼 - 페이지 12

{카테고리_이름} ASI 0391-1AC에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASI 0391-1AC 16 페이지. Soap dispenser and remote control

페이지 인쇄

1. Troubleshooting

TROUBLESHOOTING

PROBLEM

SOAP QUANTIT Y

DIMINISHED

NO SOAP COMING OUT

OF THE SPOUT

SOAP DISPENSING

FROM THE SPOUT

CONTINUOUSLY

1408201627 Rev G

INDICATOR

Low volume dispense

Red light in the sensor

flashes continuously

when the user 's hands

are within the sensor

range.

No soap dispensed.

Red light in the sensor

does not flash (once)

When user 's hands

are within the sensor

range.

Red light flashes

(once) and the motor

operates.

Steady stream of

droplets is dispensing.

CAUSE

Voltage of batteries

is low

Voltage of batteries

likely below 1.47V per

cell.

Soap level is below

supply tube.

The soap tank has

been filled but soap

has not reached the

spout.

The connector

between the motor

and the dispenser

head is not properly

engaged.

Sensor is picking up

reflections from the

washbasin or another

object.

Connectors between

the dispenser head

and the pump

assembly and/or the

power supply are

disconnected or not

properly connected.

Batteries are

completely depleted.

Soap solidification at

the supply tube.

The Com Cable

between the pump

assembly and soap

dispenser is not

connected properly.

SOLUTION

Replace batteries

Replace batteries. See

page 10.

Refer to page 9 and

refill the soap bottle.

Press the refill button

on the pump until

soap star ts to come

out of the spout

again, or press remote

"Fill" button.

Connect the Com

Cable plug and socket

properly so that the

white O-ring is not

visible. Refer to page

7 instructions.

Eliminate cause of

reflection.

Connect the plugs and

sockets correctly.

Replace batteries. See

page 10.

Fill the tank with

warm water at

120~140°F (49-60°C)

and run the pump

constantly until soap

is dispensed.