ASI FS-0700 설치 매뉴얼 - 페이지 3

{카테고리_이름} ASI FS-0700에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASI FS-0700 6 페이지. Freestanding plastic laminate sanitizing station

PODIUM MOUNTED AUTOMATIC GEL HAND SANITIZER DISPENSER (HSD) INSTALLATION GUIDE (Pg 1 of 4)

INSTALLATION

1. Install spout and sensor housing with escutcheon flange, rubber washers and basin nut (supplied)

through 1" Dia. [Ø25] mounting hole. (see Fig. 1)

2. Fix the pump to the desired location by securing the bracket with two (2) № 8-32 x 1/2" self-threading Phillips

FH stainless steel screws (provided) or hardware to suit site conditions.

COM CABLE NOT SHOWN FOR CLARITY

3. Connect flex tubing from dispenser shank to fitting on top of pump/control housing. Ensure square cut if

shortening tube from supplied length and completely insert into connector until hard stop with firm push

4. Connect spout Com-cable plug into control unit inline cable connector.

Note: Com plug should be inser ted fully so that the white O-ring is not visible and a clicking sound is

heard. If Com plug is not connected properly, the motor will run continuously. (see Fig. 3)

AMERICAN SPECIALTIES, INC.

441 Saw Mill River Road, Yonkers, NY 10701

(914) 476.9000 • (914) 476.0688

www.americanspecialties.com

THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE

MODEL №:

ISSUED:

REVISED:

Fig. 1

Fig. 2

Fig. 3

0390-HSD

30 SEP 2020

7 OCT 2020