Cyracom ClearLink Cordless 사용자 설명서 - 페이지 11

{카테고리_이름} Cyracom ClearLink Cordless에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cyracom ClearLink Cordless 17 페이지.

To pair the handsets with the base unit you must ﬁ rst follow these steps:

1) Unplug the power cord from the back of the phone.

2) Wait ten seconds.

3) Plug the power cord back in and ensure that both handsets are in the base unit and the CHARGE lights

are lit.

4) Remove both handsets from base.

To pair the main (provider) handset:

1) Phone must be in standby mode:

- Power supply plugged in

- No dial tone

2) Press and hold the CODE button on the base until you hear a beep.

3) Press and hold the "1" on the base until you hear a beep.

4) Press and hold the PAGE button on the main handset until you hear two beeps. The LED light on the

main handset will begin blinking after the ﬁ rst beep. Continue to hold the PAGE button until the

second beep occurs and the LED light stops blinking. NOTE: This may take 30-60 seconds – DO NOT

release until you hear the second beep!

5) Conﬁ rm pairing of handset by paging handset (see instructions above).

6) DO NOT place handsets back on base.

To pair the secondary (patient) handset:

1) Phone must be in standby mode:

-Power supply plugged in

-No dial tone

2) Press and hold the CODE button on the base until you hear a beep.

3) Press and hold the "2" on the base until you hear a beep.

4) Press and hold the PAGE button on the main handset until you hear two beeps. The LED light on the

main handset will begin blinking after the ﬁ rst beep. Continue to hold the PAGE button until the

second beep occurs and the LED light stops blinking. NOTE: This may take 30-60 seconds – DO NOT

release until you hear the second beep!)

5) Conﬁ rm pairing of handset by paging handset (see instructions above).

ClearLink

™

Cordless User Guide