d&b audiotechnik Ti10 사용자 설명서 - 페이지 6

{카테고리_이름} d&b audiotechnik Ti10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. d&b audiotechnik Ti10 14 페이지.
d&b audiotechnik Ti10에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지)

페이지 인쇄

pas s i ve

c r os s over

Connector wiring

Faston type connector, male single PG (standard), dual PG

(optional)

2.2 Connections

The cabinet is fitted with two NL4 M connectors. All four pins of

both connectors are wired in parallel. It uses the pin assignments

1+/1–. Pins 2+/2– are designated to actively driven subwoofers.

Using one connector as the input, the second connector allows for

direct connection to a second cabinet.

NL4 M

d&b LoadMatch

With the d&b four channel amplifier platform, the LoadMatch

function enables the amplifier to electrically compensate for the

properties of the loudspeaker cable used without the need for an

additional sense wire. For applicable loudspeakers, LoadMatch is

therefore independent of the connector type used.

WR option (Weather Resistance)

A number of d&b loudspeakers are available in special options

suitable for different types of installed applications and

environmental conditions. The following options are available for

the Ti10L loudspeaker:

▪ Weather resistant (WR): This option is suitable for outdoor use.

The cabinets have an impact and weather protected black PCP

(Polyurea Cabinet Protection) finish.

WR cabinets are equipped with a recessed connector panel

including a Faston type connector (2 x 6.3 mm, female). A cover

plate which accepts single or dual PG cable glands (Type PG13.5

for cable diameters from 6 - 12 mm) is enclosed, as shown in the

graphic opposite.

To install the fixed connection cable, please proceed as follows:

Tools required: Screw driver (#T20).

Note: Observe the correct polarity of the cable

Brown (+) / Blue (—).

1. Insert the connection cable through the PG screwing and

connect the male connector to the female connector.

2. Push the cover plate towards the connector panel until it fits

into place.

3. Fix the cover plate to the connector panel using the four

countersunk screws.

2.3 Operation

NOTICE!

Only operate d&b loudspeakers with a correctly configured d&b

amplifier, otherwise there is a risk of damaging the loudspeaker

components.

Applicable d&b amplifiers:

30D/10D/D80/D20/D12/D6.

1–

2–

d&b Ti10 Manual 1.2 en