AMBIC Foam'n'Dip 사용 설명서 - 페이지 5

{카테고리_이름} AMBIC Foam'n'Dip에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMBIC Foam'n'Dip 8 페이지. Teat dipping system

페이지 인쇄

SPECIFICATIONS

Power Source

Output

Maximum No. of Applicators per Pumping Unit

Maximum No. of Applicators operating simultaneously

Maximum Length of Distribution Tubing

Typical Chemical Consumption per Applicator (Foam)

Typical Chemical Consumption per Applicator (Dip)

Operating Temperature

PROBLEMS & FAULT FINDING

Problem

No foam (or Dip) produced

in cup when gun trigger

squeezed (ALL units)

No foam (or Dip) produced

in cup when gun trigger

squeezed (at ONE unit

only)

– Air – Farm Compressor

– Operating Pressure

– Air

Likely Cause

No Air Supply present

Air supply not

reaching applicator.

• 8 Litres/minute minimum

• 3 - 4 psi (0.2 - 0.28 bar) Max.

• 5 – 8 L/min at 3 - 4 psi (0.28

• 10

• 2

• 45 Metres

• 3 - 4 mL/second

• 10 -15 mL/second

• 5 – 40 °C

Probable Solution

Switch On Mains electricity supply to

compressor and check that tap at regulator

in ON position.

Observe the Pressure Gauge of regulator.

Disconnect the distribution tube at the outlet

of the Regulator. If plenty of air exits from

fitting then it is probable that the distribution

tubing is blocked, or restricted by over-tight

cable ties.

Check for leaking connections on

distribution tubing system.

Leaking connections, or blocked tubing –

check and remedy.

Trigger valve stuck or blocked – check valve

and lubricate with silicone aerosol.

Foaming cup dirty or blocked – clean to

remove dirt from gauzes, or replace with

new cup.

-5-

Bar max.)

FN7501 V2 (27.09.16)