Ambient NanoLockit 튜토리얼 - 페이지 2

{카테고리_이름} Ambient NanoLockit에 대한 튜토리얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient NanoLockit 5 페이지. Timecode + logging
Ambient NanoLockit에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (5 페이지), 매뉴얼 (4 페이지), 빠른 매뉴얼 (2 페이지), 매뉴얼 (19 페이지)

In this tutorial, we will show you how to timecode sync a DSLR-Camera

like the Sony Alpha 7s to an Ambient NanoLockit.

We will use the following gear: a Sony

Alpha 7s and an audio recorder.

To timecode sync this setup, you will

need two NanoLockits and these two

TC-IO-35RA timecode cables, which are

included when buying a NanoLockit.

Start the NanoLockits by pressing and

holding the power button for three sec-

onds.

The LED will flash green / red, which

means the LEMO timecode output is still

muted.

Press and hold the green button of one

NanoLockit for three seconds until LED

double-blinks green: This sets the time-

code and frame rate, wirelessly syncs all

other NanoLockits and activates all LEMO

outputs.

The NanoLockit always starts with its Real

Time Clock at last frame rate or at default

25 fps.

If successful, all units will flash green in

sync. Which means: they are ready to

sync other devices.