Ambient Technologies WMTD 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Ambient Technologies WMTD에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient Technologies WMTD 10 페이지. Wireless wall on/off/timer remote control

페이지 인쇄

1. LCD display is

blank

2. LCD display shows

"funny" display

4. Appliance does not

come on after pressing

_ on tranmitter

5. Receiver cannot

receive signal.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

50D0089 Rev 2

1. Low Battery

1. Wiring / Electrical Connections

2. Privacy (DIP) switch setting on transmitter

does not match receiver

3. Transmitter measures temperature exceeding

99 degrees Fahrenheit and shows "HI" on LCD

4. Distance between the transmitter and receiver

is more than 30 feet

1. Receiver is installed in an enclosure

2. Battery installed wrong

WARRANTY

Page 9 of 10

1. Replace batteries. Change

batteries every 6 months.

2. Check battery installation and

replace batteries.

3. Press Reset button.

1. Slide the switch to ON, if

appliance comes ON, wiring is not

the cause.

2. If appliance does not come on,

check wiring connections.

1. Make sure the transmitter and

receiver has the same DIP switch

settings.

1. Move transmitter to a cooler

place and wait until temperature

drops below 99 degree.

1. Make sure the operating distance

is less than 30 feet

1. Make sure the receiver is not

located inside an enclosure.

2. Install battery correctly in the

receiver.

Ambient Technologies

A Division Of MHS