Ambient Technologies WMTD Quick Start Manual - Page 9
Browse online or download pdf Quick Start Manual for Remote Control Ambient Technologies WMTD. Ambient Technologies WMTD 10 pages. Wireless wall on/off/timer remote control
Print Page1. LCD display is
blank
2. LCD display shows
"funny" display
4. Appliance does not
come on after pressing
_ on tranmitter
5. Receiver cannot
receive signal.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
50D0089 Rev 2
1. Low Battery
1. Wiring / Electrical Connections
2. Privacy (DIP) switch setting on transmitter
does not match receiver
3. Transmitter measures temperature exceeding
99 degrees Fahrenheit and shows "HI" on LCD
4. Distance between the transmitter and receiver
is more than 30 feet
1. Receiver is installed in an enclosure
2. Battery installed wrong
WARRANTY
Page 9 of 10
1. Replace batteries. Change
batteries every 6 months.
2. Check battery installation and
replace batteries.
3. Press Reset button.
1. Slide the switch to ON, if
appliance comes ON, wiring is not
the cause.
2. If appliance does not come on,
check wiring connections.
1. Make sure the transmitter and
receiver has the same DIP switch
settings.
1. Move transmitter to a cooler
place and wait until temperature
drops below 99 degree.
1. Make sure the operating distance
is less than 30 feet
1. Make sure the receiver is not
located inside an enclosure.
2. Install battery correctly in the
receiver.
Ambient Technologies
A Division Of MHS