Ambient Weather WS-1285 사용자 설명서 - 페이지 3

{카테고리_이름} Ambient Weather WS-1285에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient Weather WS-1285 16 페이지. Advanced weather station

FRONT VIEW

2.4 Display Console Set Up

Note: To avoid permanent damage, please take note of the battery polarity before inserting the

batteries.

Move the remote thermometer at least 10' away from the display console (if the sensor is too close, it

may not be received by the display console).

Remove the battery door on the back of the display. Insert three AA (alkaline or lithium, avoid

rechargeable) batteries in the back of the display console.

All of the LCD segments will light up for a few seconds to verify all segments are operating properly.

Replace the battery door, and fold out the desk stand and place the console in the upright position.

The console will instantly display indoor temperature, date and time. The outdoor temperature and

humidity will display --, then update on the display within a few minutes. Do not touch any buttons

until the remote sensor reports in, otherwise the remote sensor search mode will be terminated, and

you must power down and power up the console again. When the remote sensor data has been

received, the console will automatically switch to the normal mode, and all further settings can be

performed.

If the remote does not update, please reference the troubleshooting guide in Section 7.

Note: The following illustration shows the full segments of the LCD for description purposes

Version 1.0

BACK VIEW

Figure 1

Page 3