Ambient Weather WS-1285 Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Stacja pogodowa Ambient Weather WS-1285. Ambient Weather WS-1285 16 stron. Advanced weather station

FRONT VIEW

2.4 Display Console Set Up

Note: To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
Move the remote thermometer at least 10' away from the display console (if the sensor is too close, it
may not be received by the display console).
Remove the battery door on the back of the display. Insert three AA (alkaline or lithium, avoid
rechargeable) batteries in the back of the display console.
All of the LCD segments will light up for a few seconds to verify all segments are operating properly.
Replace the battery door, and fold out the desk stand and place the console in the upright position.
The console will instantly display indoor temperature, date and time. The outdoor temperature and
humidity will display --, then update on the display within a few minutes. Do not touch any buttons
until the remote sensor reports in, otherwise the remote sensor search mode will be terminated, and
you must power down and power up the console again. When the remote sensor data has been
received, the console will automatically switch to the normal mode, and all further settings can be
performed.
If the remote does not update, please reference the troubleshooting guide in Section 7.

2.4.1 Display Console Layout

Note: The following illustration shows the full segments of the LCD for description purposes
Version 1.0
©Copyright 2011, Ambient LLC. All Rights Reserved.
BACK VIEW
Figure 1
Page 3