ACR Electronics ARTEX GLOBALFIX V4 제품 지원 매뉴얼 - 페이지 7
{카테고리_이름} ACR Electronics ARTEX GLOBALFIX V4에 대한 제품 지원 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics ARTEX GLOBALFIX V4 20 페이지. 406 mhz gps epirb
ACR Electronics ARTEX GLOBALFIX V4에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (11 페이지)
페이지 인쇄
Manual Deployment and Activation
To manually deploy and activate a Category I or II beacon, you must do the following:
1.)
Remove the beacon from its bracket.
2.)
Activate the beacon by placing it in the water.
OR, slide the Activation Button Cover toward and over the self-test button, thus breaking the Protective Witness Seal.
Then, press the Activation Button for a minimum of two seconds or until the red LED starts to flash.
NOTE: Once the protective activation witness seal has been broken, it can only be replaced by an ACR Battery
Replacement Center.
Manual Activation without Deployment
A Category I or II beacon can also be manually activated while still in its bracket by pressing the activation button as
described above. For proper beacon operation when activated in the bracket, ensure that the beacon has a clear view to
the sky.
Turning Off the Beacon
If your beacon was manually activated and you wish to deactivate, push the activation button for 3 seconds or
until the LEDs stop flashing.
If your beacon was automatically activated (water activated) and you wish to deactivate, remove the beacon from the
water and dry the unit. The beacon normally takes up to 10 seconds to deactivate.
WARNING: If deactivation should fail, remove the bottom screw holding the battery to the unit, and separate the
battery from the main body of the EPIRB to disable the unit. Return the beacon to ACR Electronics for service.
7 |
P a g e