ambiq micro Apollo3 Blue Plus 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} ambiq micro Apollo3 Blue Plus에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ambiq micro Apollo3 Blue Plus 15 페이지.

Software Development Tools

The standard Segger J-Link debug interface is used on the Apollo3 Blue Plus EVB. Please install the latest

Segger J-Link software, and configure your preferred development IDE (Keil, IAR, or Eclipse) to use J-Link

debug interface.

Links to development tools that support Apollo3 Blue Plus:

SEGGER J-Link Software (6.48b Beta or later)

▪

▪ KEIL uVision 5 (MDK5.25 or later):

▪ New Keil Pack (Also used by Eclipse):

▪ IAR Version (8.10.1 or later):

edition/

▪ GCC 5.3.1:

https://gcc.gnu.org

Regardless of preferred IDE, please install the Segger J-Link software. All of the above development

environments support J-Link, but you must have the latest J-Link software installed. Most alternate

development environments also are supported by J-Link.

Please refer to the AmbiqSuite Getting Started Guide (AMSDKGS) at

uploads/2017/09/AMSDKGS-v1_1.pdf

QS_A3P_1p1

https://www.segger.com/downloads/jlink

https://www.keil.com/demo/eval/arm.htm

http://www.keil.com/dd2/pack/#/third-party-download-dialog

https://www.iar.com/iar-embedded-workbench/tools-for-arm/arm-cortex-m-

for more details on setting up development IDEs to use J-Link.

Page 10

Apollo3 Blue Plus EVB Quick Start Guide

Ultra-Low Power Apollo MCU Family

https://ambiqmicro.com/wp-content/

2020 Ambiq Micro, Inc.