ambiq micro Apollo3 Blue Plus 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} ambiq micro Apollo3 Blue Plus에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ambiq micro Apollo3 Blue Plus 15 페이지.

Debug Interface

The debug interface is supported by standard J-Link drivers from Segger. Please refer to "Software

Development Tools" on page 10 for more details on J-Link debug support.

4.1

Use of External Debugger

This EVB also supports the use of an external Cortex SWD debug interface through a standard 10-pin

debug header (DEBUG IN - J1) as shown in Figure 3.

Figure 3. Apollo3 Blue Plus EVB's Cortex DEBUG IN Header (J1)

No jumper changes are required to use an external debug adapter. Simply connect the external debug

adapter with a 10-pin ribbon cable connector to the "DEBUG IN" header.

4.2

Use of J-Link Adapter as an External Target Board Debugger

The EVB also offers the ability to be used as a J-Link debug adapter for any target board that has an

Apollo family MCU.

QS_A3P_1p1

Apollo3 Blue Plus EVB Quick Start Guide

Ultra-Low Power Apollo MCU Family

Page 8

2020 Ambiq Micro, Inc.