ambiq micro Apollo4 Blue Plus 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} ambiq micro Apollo4 Blue Plus에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ambiq micro Apollo4 Blue Plus 19 페이지.

Apollo4 Plus Display Kit Quick Start Guide

Quick Start

The Apollo4 Plus Display Kit comes with the following items:

▪ Apollo4 Plus Evaluation Board (EVB), revision 2

▪ Apollo4 Plus Display Shield, revision 1

▪ USB Type C cable

▪ Four adhesive-backed rubber feet

▪ Extra jumpers

Caution: The EVB has components loaded on the back of the board. Care should be taken to not damage

these components. The included rubber feet should be applied to the bottom of the board to prevent direct

contact between the components and a desk surface.

The EVB in the Apollo4 Plus Display Kit comes with jumpers pre-configured for default operation. Also, it

has been pre-programmed with the Binary Counter example program. To begin EVB program execution,

first carefully attach the Apollo4 Plus Display Shield to the Apollo4 Plus EVB if not already attached. To do

this, press the two boards together as evenly as possible until the display shield is fully seated on the

connectors of the EVB. Then connect the USB-C cable from a USB port on a PC to the J-Link USB

connector (J6) on the EVB, and make sure the power switch (SW4) has been turned on. The LEDs on the

bottom of the EVB should begin to count up in binary, from 0 to 7.

The AmbiqSuite SDK provides many example programs that may be run on the Display Kit. To run these

examples, download the SDK via the link provided above and select any of the pre-built examples in the

SDK at /boards/apollo4p_evb_disp_shield_rev2/examples.

QS-A4PDK-1p0

Page 9

2022 Ambiq Micro, Inc.