ambiq micro Apollo4 Blue EVB 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} ambiq micro Apollo4 Blue EVB에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ambiq micro Apollo4 Blue EVB 18 페이지. Evb display kit
ambiq micro Apollo4 Blue EVB에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (20 페이지)

페이지 인쇄

Apollo4 Display Kit Quick Start Guide

Quick Start

The Apollo4 Display Kit comes with the following items:

▪ Apollo4 Evaluation Board (EVB), revision 3

▪ Apollo4 Display Shield, revision 1

▪ USB Type C cable

▪ Four adhesive-backed rubber feet

▪ Extra jumpers

Caution: The EVB has components loaded on the back of the board. Care should be taken to not damage

these components. The included rubber feet should be applied to the bottom of the board to prevent direct

contact between the components and a desk surface.

The EVB in the Apollo4 Display Kit comes with jumpers pre-configured for default operation. Also, it has

been pre-programmed with the nemagfx_balls_bench example program. To begin EVB program

execution, first carefully attach the Apollo4 Display Shield to the Apollo4 EVB. Press the two boards

together as evenly as possible until the display shield is fully seated on the connectors of the EVB. Then

connect the USB-C cable from a USB port on a PC to the J-Link USB connector (J6) on the EVB, and turn

on the power switch (SW4). The blue LED under the power switch should illuminate. The display should

immediately display balls of various colors and sizes bouncing around the display, blending their colors

where they intersect.

The AmbiqSuite SDK provides many example programs that may be run on the Display Kit. To run these

examples, download the SDK via the link provided above and select any of the pre-built examples in the

SDK at /boards/apollo4b_bga_evb_disp_shld/examples.

QS-A4DK-1p1

Page 9

2023 Ambiq Micro, Inc.