FLO-DYNAMICS CMS-120 Quick Start Instructions - Page 2

Browse online or download pdf Quick Start Instructions for Industrial Equipment FLO-DYNAMICS CMS-120. FLO-DYNAMICS CMS-120 8 pages. Coolant management system

Print Page

40201194

CMS-120

QUICK START

Coolant Management System

INSTRUCTIONS

When air is seen in the black hose, turn Tank Control and

Assist Control to VENT and Vacuum Control to OFF.

When air pockets/coolant stop moving in the service hoses,

move the Flow Control to "OFF".

Close the ball valves and remove the service hoses.

PERFORM COOLANT FILL OPERATION

RETURN COOLANT TO VEHICLE AFTER SERVICING

Move the Flow Control to "OFF" and connect shop air.

Connect the red service hose to highest point, the black

service hose to the lowest point, and open the ball valves.

Turn all control panel dials to the GREEN position.

Move the Flow Control to "ON".

The system will begin to fill.

When the coolant level is at the "cold" level of the

expansion tank or seen in the red hose, the system is full.

Turn Tank Control to VENT and Vacuum Control to OFF.

The coolant level will adjust.

Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874

Page 2 of 8