AMERICAN SNIPER STEAMASTER Safety, Operation And Maintenance Manual With Parts List - Page 4
Browse online or download pdf Safety, Operation And Maintenance Manual With Parts List for Floor Machine AMERICAN SNIPER STEAMASTER. AMERICAN SNIPER STEAMASTER 9 pages. 500 psi pump, dual 3-stage motor
2.0 Set-Up / Prepare Unit for Use
DO NOT USE ON WET SURFACES. DO NOT EXPOSE TO RAIN. STORE
INDOORS.
• All carpet extractors, no matter what the time of year, are shipped with antifreeze in
the solution lines. Prior to first use, fill the solution tank with one quart of warm water.
Attach the hose and using a hand tool or wand, flush out the system by spraying the
one quart of water through the pump.
• Attach the vacuum hose and the brass quick disconnect.
• Fill the solution tank with warm water (less than 100 degrees Fahrenheit). Fill to
approximately 4 inches from the top. Pre-spray and agitate the surface with detergent
made for floor cleaning or upholstery. Use only warm water to extract the pre-spray
from the surface.
• Be sure to replace any filters back into the machine prior to use.
• Do not use citric acid, butyl glycol or harsh degreasers inside the machine.
2.1
Electrical
Plug cord(s) into 10 AMP grounded wall outlet(s). 10 AMP circuits are normally found in
kitchens and bathrooms. Never remove ground prong from the plug. If a circuit breaker
trips during operation, turn machine off, reset the breaker and move the electrical cord to
a different outlet and resume operation.
2.2
Vacuum System
Automatic Vacuum Shut-Off: The float assembly shut-off, located in the recovery
tank on the vacuum stand pipe, prevents the waste tank from overflowing into the stand
pipe and damaging the vacuum motor(s). The float assembly will cut-off vacuum to the
waste tank. The motor(s) will also reach a fast, high-pitched sound alerting you when the
recovery tank is about to over flow. When this happens, immediately turn off the vacuum
motor(s) and empty the waste tank. If the operator continues to use machine after the tank
is full, it will void the Warranty.
The float assembly has a filter to prevent lint and debris from entering the stand pipe.
Refer to the "Maintenance" section for removal and proper cleaning.
Recovery Tank: the vacuum system requires the use of an external filter. The clear
view in-line filter is included with the machine and must be used on every job.
It is also necessary to use a defoamer to eliminate foam build-up in the recovery
tank which could lead to foam/moisture entering the vacuums and contributing to
early failure of the vacuum motors.
If moisture does enter the vacuum motors, contact an authorized service center. To
prevent moisture from damaging the vacuum motors during storage, empty the recovery
tank and store with the lid open.
(4) 12-Gallon, 500 PSI Carpet Extractor
9.0 Machine Parts List Continued
Item No.
Item Description
10-0807
Wheels for Extractor
10-0834
Pump Flat Washer
10-0835-N
Nut for Pump Bolt on Extractor
10-0808
Caster for Extractor
10-0816
Caster Bolt 1/4-20 x 1/2 Hex Bolt
10-0843-COM
1/2" x 54" Clear Hose for Extractor Pump
Includes Fittings and Filter
80-0040-C
46" of Blue 3000 psi Hose for Extractor
Complete with Fittings and Clamps
80-0044-S
30" Black Hose with Fittings and Clamps
10-0835-N
Nut for Pump Bolt on Extractor
Hose Fitting
Part of 80-0044-S
Hose Fitting
Part of 80-0040-C
80-0015
500 psi Pump Mount Plate
10-0833
Motor Manifold Bolts for Extractor
80-0044-L
67" Black Hose with Fittings and Clamps
Hose Fitting
Part of 80-0044-L
Hose Fitting
Part of 80-0044-S
10-0881
1/4" MNPT x 3/8" JIC 90 Degree -
Part of 80-0044-S
80-0016
500 psi Pump
10-0835-B
Pump Bolt for Extractor
80-0036
Locking Plate
10-0832
S/R Strap Bolts
10-0040
3000 psi Blue Hose - Part of 80-0040-C
80-0026
3/8" Barb x 1.4" MPT 90 Degree -
Part of 80-0040-C
80-0017
Bulk Head fitting for Extractor
10-0379
8-32 x 3/8 Screw
10-0868
1/4" Female QD for Extractor
10-0831
S/R Bracket for Extractor
80-0035
Bracket
80-0037
RFI Filter
80-0005-C
10 amp Circuit Breaker
Qty.
Drawing No.
2
48
18
49
8
50
2
51
12
52
1
53
1
54
1
55
4
56
57
58
1
59
4
60
1
61
62
63
1
64
1
65
4
66
1
67
4
68
6
69
1
70
3
71
8
72
1
74
2
75
1
Not Pictured
1
Not Pictured
1
Not Pictured
12-Gallon, 500 PSI Carpet Extractor (13)