AMERICAN SNIPER STEAMASTER Instrukcja bezpieczeństwa, obsługi i konserwacji z listą części - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja bezpieczeństwa, obsługi i konserwacji z listą części dla Maszyna podłogowa AMERICAN SNIPER STEAMASTER. AMERICAN SNIPER STEAMASTER 9 stron. 500 psi pump, dual 3-stage motor

Drukuj stronę

2.0 Set-Up / Prepare Unit for Use

DO NOT USE ON WET SURFACES. DO NOT EXPOSE TO RAIN. STORE

INDOORS.

• All carpet extractors, no matter what the time of year, are shipped with antifreeze in

the solution lines. Prior to first use, fill the solution tank with one quart of warm water.

Attach the hose and using a hand tool or wand, flush out the system by spraying the

one quart of water through the pump.

• Attach the vacuum hose and the brass quick disconnect.

• Fill the solution tank with warm water (less than 100 degrees Fahrenheit). Fill to

approximately 4 inches from the top. Pre-spray and agitate the surface with detergent

made for floor cleaning or upholstery. Use only warm water to extract the pre-spray

from the surface.

• Be sure to replace any filters back into the machine prior to use.

• Do not use citric acid, butyl glycol or harsh degreasers inside the machine.

2.1

Electrical

Plug cord(s) into 10 AMP grounded wall outlet(s). 10 AMP circuits are normally found in

kitchens and bathrooms. Never remove ground prong from the plug. If a circuit breaker

trips during operation, turn machine off, reset the breaker and move the electrical cord to

a different outlet and resume operation.

2.2

Vacuum System

Automatic Vacuum Shut-Off: The float assembly shut-off, located in the recovery

tank on the vacuum stand pipe, prevents the waste tank from overflowing into the stand

pipe and damaging the vacuum motor(s). The float assembly will cut-off vacuum to the

waste tank. The motor(s) will also reach a fast, high-pitched sound alerting you when the

recovery tank is about to over flow. When this happens, immediately turn off the vacuum

motor(s) and empty the waste tank. If the operator continues to use machine after the tank

is full, it will void the Warranty.

The float assembly has a filter to prevent lint and debris from entering the stand pipe.

Refer to the "Maintenance" section for removal and proper cleaning.

Recovery Tank: the vacuum system requires the use of an external filter. The clear

view in-line filter is included with the machine and must be used on every job.

It is also necessary to use a defoamer to eliminate foam build-up in the recovery

tank which could lead to foam/moisture entering the vacuums and contributing to

early failure of the vacuum motors.

If moisture does enter the vacuum motors, contact an authorized service center. To

prevent moisture from damaging the vacuum motors during storage, empty the recovery

tank and store with the lid open.

(4) 12-Gallon, 500 PSI Carpet Extractor

9.0 Machine Parts List Continued

Item No.

Item Description

10-0807

Wheels for Extractor

10-0834

Pump Flat Washer

10-0835-N

Nut for Pump Bolt on Extractor

10-0808

Caster for Extractor

10-0816

Caster Bolt 1/4-20 x 1/2 Hex Bolt

10-0843-COM

1/2" x 54" Clear Hose for Extractor Pump

Includes Fittings and Filter

80-0040-C

46" of Blue 3000 psi Hose for Extractor

Complete with Fittings and Clamps

80-0044-S

30" Black Hose with Fittings and Clamps

10-0835-N

Nut for Pump Bolt on Extractor

Hose Fitting

Part of 80-0044-S

Hose Fitting

Part of 80-0040-C

80-0015

500 psi Pump Mount Plate

10-0833

Motor Manifold Bolts for Extractor

80-0044-L

67" Black Hose with Fittings and Clamps

Hose Fitting

Part of 80-0044-L

Hose Fitting

Part of 80-0044-S

10-0881

1/4" MNPT x 3/8" JIC 90 Degree -

Part of 80-0044-S

80-0016

500 psi Pump

10-0835-B

Pump Bolt for Extractor

80-0036

Locking Plate

10-0832

S/R Strap Bolts

10-0040

3000 psi Blue Hose - Part of 80-0040-C

80-0026

3/8" Barb x 1.4" MPT 90 Degree -

Part of 80-0040-C

80-0017

Bulk Head fitting for Extractor

10-0379

8-32 x 3/8 Screw

10-0868

1/4" Female QD for Extractor

10-0831

S/R Bracket for Extractor

80-0035

Bracket

80-0037

RFI Filter

80-0005-C

10 amp Circuit Breaker

Qty.

Drawing No.

Not Pictured

12-Gallon, 500 PSI Carpet Extractor (13)