AMERICAN SPORTSWORKS CREWMATE 16265 Installation Instructions

Browse online or download pdf Installation Instructions for Automobile Accessories AMERICAN SPORTSWORKS CREWMATE 16265. AMERICAN SPORTSWORKS CREWMATE 16265 4 pages. Tool rack for straight brush bar units

Print Page

800-643-7332

As illustrated below, this kit contains:

16310-2 crew mate LH side panel

16311-2 crew mate RH side panel

16305-2 crossbar

16306

utility shelf

16360

small tool clamp kit (2 clamps per kit) Qty: 2

16361

large tool clamp kit (2 clamps per kit) Qty: 2

16270

screw, 5/16" - 18 x .75 socket head

16277

screw, 5/16" - 18 x 2.5 socket head

16300

nut, 5/16"-18 nylon lock w/ flange

16301

u-bolt, 5/16"-18 x 1.25"

16302

washer, 5/16" SAE flat washer

16311-2

16360 small tool clamp

(2 clamps per kit - total of 4)

16305-2

16310-2

Refer to figure 1. Remove overhead bar bolt. Hold side panel up and align bolt holes

and insert 16277 (2.5") bolt and 16302 washer. Attach 16300 nyloc nut. Do not

completely tighten. Insert 16301 u-bolt under top seat back bar and behind seat

cushion. Attach 16300 nyloc nuts to u-bolt. Do not completely tighten. Repeat with

opposite side panel. Side panels can hang freely for remainder of installation.

Note: If U-bolt installation is tight, loosen phillips head screws on seat back

cushion. Seat back cushion does not need removed.

driver side overhead bar

16302

16277

16301

fig. 1

16300

CREWMATE

TOOLS REQUIRED

Qty: 1

5/32" Hex driver

Qty: 1

¼" Hex driver

Qty: 1

½" Wrench

Qty: 1

Phillips head screw driver

Additional shelves and clamps are

available from American SportWorks.

Qty: 4

Qty: 2

Qty: 10

Qty: 2

16306

Qty: 6

16361 large tool clamp

(2 clamps per kit - total of 4)

16300

16310-2

16302

16300

TOOL RACK FOR STRAIGHT BRUSH BAR UNITS (16265)

™

SEE PAGE 2 FOR INSTRUCTIONS IF YOUR VEHICLE

fig. 2

Finished installation

16270

fig. 3

Hold crossbar between side panels. Insert (4x) 16270 screw and 16302 washer.

Attach 16300 nyloc nut as shown in figure 1. Proper finished installation can be

seen in figures 2 & 3.

Insert 16306 shelf at angle and align channel nuts with channel. Insert opposite

end into channel as shown in figure 4. Channel nuts twist lock. Make sure the

channel nut is square in the channel as shown in figure 6. Tighten all fasteners

on the CrewMate™ at this time.

HAS A HARD TOP / ENCLOSURE.

page 1 of 4

16160