AMERICAN SPORTSWORKS CREWMATE 16265 Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Automobile Accessories AMERICAN SPORTSWORKS CREWMATE 16265. AMERICAN SPORTSWORKS CREWMATE 16265 4 pages. Tool rack for straight brush bar units

Print Page

fig. 4

Shelf and clamp installation

Attach 16360 small tool clamps and 16361 large tool clamps. Channel nuts twist

lock. Note: 2 clamps required per tool.

Position clamps for desired tool placement. Double check that all fasteners are

tight before use. Clamps can be rotated by removing the screws and placing in a

desired position as shown in figure 5.

fig. 5

clamp rotation

FOR UNITS WITH A HARD TOP INSTALLED

Before attaching the CrewMate™, remove the hard top from the vehicle. Use the

provided templates to make cuts on the hard top.

Gloves, marker, eye protection, Dremel® with routing bit (recommended) or use drill,

2" hole saw drill bit and saw will be additionally required.

Carefully cut out the corner of template 1 following the dotted line. Place edges of

template 1 on hard top back edges following directions on template 1. Using a

marker, trace the template 1 profile onto the hard top.

Using a Dremel® tool or equivalent device to cut plastic, carefully cut along the

drawn profile.

Repeat steps above for the opposite side of the hard top. Flip over template page

for correct orientation on the opposite side of the hard top.

Install hard top. Install 16265 CrewMate™ following the instructions provided.

Additional shelves and clamps are

available from American SportWorks.

fig. 6

FOR UNITS WITH AN ENCLOSURE INSTALLED

16265 CrewMate™ UTV Rack installation with swing door enclosure or zipper door

enclosure, follow these additional steps:

Gloves, box cutter (or equivalent), marker, eye protection.

Before attaching the CrewMate™, install the enclosure onto the vehicle. Use the

provided templates to make cuts on enclosure.

Using template 2, place circle over top, rear overhead bar attachment bolt head for

proper alignment. Lines should be towards the rear of vehicle.

Using a marker and the lines from template 2, draw two small lines behind the stitch

seam to mark the boundaries of the first cut. Using template 2 connect the two

boundary lines by drawing a line between them.

Using a cutting tool, carefully cut the enclosure along the line created in step 2.

Using template 3 align one line with the cut made in step 3. The second line on

template 3 should be closer to the center of the vehicle. Using a marker, draw a small

line to mark where the second cut will be located.

Use template 2 and a cutting tool to carefully make the second cut parallel and equal in

size to the first cut made then install side panel top mount to overhead bar following the

instructions provided. Let side panel remain suspended once top mount is attached.

Align side panel bottom mount with seat back tube. Use side panel bottom mount holes

and marker to draw two dots on enclosure. Using a cutting tool, carefully cut small slits

in the enclosure where the two dots where marked and install the side panel bottom

mount to seat back following the instructions provided. Repeat the above steps for the

opposite side panel and install remaining 16265 CrewMate™ parts following the

instructions provided.

fig. 7 Side panel top mount

fig. 8 Side panel bottom mount

page 2 of 4

16160