American Standard YORKVILLE 2878.100 Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Toilets American Standard YORKVILLE 2878.100. American Standard YORKVILLE 2878.100 4 pages. 1.1 gpf two-piece pressure-assisted toilets, 1.1 gpf two-piece pressure-assisted toilets

Print Page
con't. FOR CADET TOILETS:
INSTALL
4-1
WAX SEAL
Invert toilet on floor
(cushion to prevent
damage), and install
wax ring evenly
around waste flange
(horn), with tapered
end of ring facing
toilet. Apply a thin
bead of sealant
around base flange.
5-1
NUT
TAPERED
WASHER
CLOSET
BOLT
INSTALL TOILET ON FLANGE
a. Unplug floor waste opening and install toilet on closet
flange so bolts project through mounting holes.
b. Loosely install retainer washers and nuts. Side of
washers marked "THIS SIDE UP" must face up!
6-1
BOLT CAP
CLOSET
BOLT
WASHER
NUT
INSTALL TOILET
a.
Position toilet squarely to wall and, with a rocking motion,
press bowl down fully on wax ring and flange.
Alternately tighten nuts until toilet is firmly seated on floor.
CAUTION: DO NOT OVERTIGHTEN NUTS
!
OR BASE MAY BE DAMAGED!
b.
Install caps on washers. (If necessary, cut bolt height to
size before installing caps.)
c.
Smooth off the bead of sealant around base. Remove
excess sealant.
WAX
SEALANT
RING
FLANGE
CLOSET FLANGE
con't. FOR YORKVILLE TOILETS:
4-2
INSTALL NEOPRENE OR GRAPHITE FELT SEAL*
Install seal evenly
around waste flange
(horn). Apply a thin
bead of sealant
around base flange.
* Note: Wax seal not
recommended for this
application.
5-2
LAG
BOLT
TAPERED
WASHERS
INSTALL TOILET ON FLANGE
a. Unplug floor waste opening and install toilet on closet
flange so bolts project through mounting holes.
b. Loosely install retainer washers and nuts. Side of
washers marked "THIS SIDE UP" must face up!
6-2
BOLT
CAP
NUT & WASHER
BOLT
CAP
BOLT
HEAD
WASHER
INSTALL TOILET
a.
Position toilet squarely to wall and, with a rocking motion,
push bowl against ring and flange. Alternately tighten nuts
until toilet is firmly anchored.
CAUTION: DO NOT OVERTIGHTEN NUTS
!
OR BASE MAY BE DAMAGED!
b.
Insert the tapered washers (supplied in the kit) into the
lag bolts (not supplied). Insert bolts through mounting holes
and tighten into pre-drilled floor openings.
c.
Install the four bolt caps on tapered washers. (If necessary,
cut wall bolt length to size before installing caps.)
d.
Smooth off the bead of sealant around base.
Remove excess sealant.
- 2 -
SEALANT
NEOPRENE
SEAL
FLANGE
FLANGE
BOLTS
7 3 012 76 - 10 0 Rev. A