American Standard WALK-IN BATH Installation Instructions And Owner's Manual - Page 12
Browse online or download pdf Installation Instructions And Owner's Manual for Hot Tub American Standard WALK-IN BATH. American Standard WALK-IN BATH 15 pages. Walk-in bath
Print Page
1. Enter the American Standard® walk-in bath, close the door, place handle in down position, and fill the bath
to at least 2 inches above the highest jet before activating the pump. Do not put weight on the door when
entering and exiting the tub. It is recommended to leave the door in the open position when the tub is not in
use.
2. The pump is operated by the on/off switch. Both the number of buttons and their assorted functions vary.
Do not depress the button(s) repeatedly and/or rapidly as all function(s) are controlled electronically. It may
take a few seconds before any change becomes perceptible. Refer to massage instructions sheet for more
information on the controls.
3. Adjust the direction and rate of flow of the jets in the calf and foot area to your liking by moving the nozzle
for direction and turning either the outside ring or the nozzle clockwise or counterclockwise for flow (some
jets adjust the flow with the outside ring and some with the nozzle). Adjust the flow of all jets by using the
Hi-Med-Low switch which varies the speed of the pump or adjust the flow of the jets above the seat with
the legs-only massage handle mounted on the sidewall of the tub.
4. The Legs Massage (whirlpool systems only) opens and closes jets above the seat which allows you to fill
the tub half-way and operate the lower whirlpool jets. The Legs Massage valve must be closed
when filling the tub half-way and operating the whirlpool. Failure to close the valve, when filling the tub
half-way will result in water shooting out of the jets above the seat when the pump is activated.
5. If your American Standard® walk-in bath is equipped with an in-line heater, the heating element will come
on automatically, but only when the whirlpool system is turned on. This heater is designed to extend the
comfortable bathing time, but does not reheat the bath water.
6. If your American Standard® walk-in bath is equipped with the Automatic Tub Clean System - Ozone, the
system will turn on automatically when the whirlpool system is turned on.
7. If your American Standard® walk-in bath is equipped with the Quick Drain
dedicated pump, suction and switch to activate the drain. Simply open the traditional drain system (turn the
overflow) and then press the Quick Drain™ on/off switch to activate the drain. When the water falls below
the suction guard, press the on/off switch to turn the drain system off.
8. If your American Standard® walk-in bath is equipped with Chromatherapy lights, the lights have a
dedicated on/off switch. Pressing the switch off and back on will change the color of light.
9. If any factory-installed fittings have been removed, do not operate the unit. A safety hazard may have been
SAVE THESE INSTRUCTIONS!
OPERATING INSTRUCTIONS
11
OWNERS MANUAL
TM
, this system has its own