American Standard 1662SG.221 Installation Instructions - Page 3

Browse online or download pdf Installation Instructions for Kitchen & Bath Fixtures American Standard 1662SG.221. American Standard 1662SG.221 5 pages. Commercial shower system kits: 1.5 gpm & 2.5 gpm

Print Page

INSTALLATION INSTRUCTIONS

The GRAB BAR (1) works best when secured to the wall studs or cross brace using WOOD SCREWS. If mounting

into the studs is not possible, use appropriate wall fasteners provided to secure the installation.

Mark a vertical center line in the location you wish to install the SLIDE BAR (1). NOTE: The height from the finished floor

is optional. See rough-in drawing for suggested dimensions.

Determine desired height from the finished floor to the lower support and mark a horizontal center line. Slide the two

WALL ESCUTCHEONS (5) away from the MOUNTING FLANGES (3). Position the GRAB BAR (1) as shown in Fig. A and

mark the location of the six mounting holes to be drilled. Fig. A. Using a #10 masonry drill, drill six mounting holes

1-1/4" max. deep. Fig. B.

Install the six ANCHORS (2) provided into the mounting holes. Use a hammer to lightly tap ANCHORS (2) into place.

Make sure they are installed flush against the finished wall. Fig. B.

Align and place the GRAB BAR MOUNTING FLANGES (3) over the installed ANCHORS (2). Secure the GRAB BAR (1)

to the wall with the SCREWS (4) provided. Fig. B.

Push WALL ESCUTCHEONS (5) against finished wall. Rotate WALL ESCUTCHEONS (5) clockwise to lock into

position. Fig. C.

Make sure larger diameter side of SPRAY HOLDER (6) is facing upward. If not rotate SPRAY HOLDER (6) 180 dergees.

Rotate the LEVER HANDLE (7) to the unlocked position. Push the SPRAY HOLDER (6) side onto the GRAB BAR (1).

Push the LEVER HANDLE SIDE (7) over the SPRAY HOLDER ARMS (8) until the two snap togerther.

Check operation of SLIDE BAR (1) by rotating HOLDER LEVER (7) and moving HAND SHOWER HOLDER (9) up and down.

Rotate LEVER HANDLE (7) back to lock HAND SHOWER HOLDER (6). Fig. B.

Fig. A

C/L

914mm

(36")

OPTIONAL TO FINISHED FLOOR

FINISHED

FLOOR

Fig. B

VERTICAL

CENTER LINE

LEVEL

USUALLY BETWEEN

915mm

1525mm

(36")

(60")

DRILLED

MOUNTING

HOLES

LARGE

DIAMETER UP

Fig. C

LOCK

M 9 6 5 6 6 6 R ev. 1. 0 ( 1 / 17 )

ROTATE

CLOCKWISE

TO LOCK

UNLOCK