Dongcheng DSB02-185 Operation Instructions Manual - Page 4

Browse online or download pdf Operation Instructions Manual for Sander Dongcheng DSB02-185. Dongcheng DSB02-185 6 pages. Orbital sander

Print Page

Installing or Removing Abrasive Paper

CAUTION:

Always be sure that the tool is

switched off and unplugged before

installing or removing the paper.

To install the abrasive paper, first turn

the lever clip to the position showed in

Fig.1.

Then insert one paper end between

the base and the paper clamp and

keep paper end parallel with the base

side. (Fig.2)

Once inserted well, return the lever

clip to the original position. Overcast

the pad with the paper and repeat the

same process for the other end of the

base, maintaining the proper paper

tension. (Fig.3)

Make sure the abrasive paper is

clamped securely or the sanding

maybe uneven caused by loosen or sliding of abrasive paper.

Switch Operation

-5-

CAUTION:

 Before plugging in the tool, always check

to see that the trigger switch actuates

properly and returns to the "OFF" position

when released.

To start the tool, simply pull the trigger.

Release the trigger to stop. For continuous

operation, pull the trigger and then push in

the lock button. To stop the tool from the

locked position, pull the trigger fully, and

then release it. (Fig. 4)

Sanding Operation

Hold the tool firmly. Turn the tool on and

wait until it attains full speed. Then gently

place the tool on the workpiece surface.

Keep the pad flush with the workpiece and

apply slight pressure on the tool. (Fig. 5)

An orbital sander is generally used to

remove only a small amount of material at

a time. Since the quality of the surface is

more important than the amount of stock

removed, do not bear down on the tool.

You can put a high polish on furniture or other fine surfaces by using a cloth under the

tool.

CAUTION:

 Do not block motor vent with your finger or hand.

 Never run the tool without paper. You may seriously damage the pad.

 Never force the tool. Excessive pressure may decrease the sanding efficiency,

-6-