American Time SiteSync IQ Installation And Operation Manual - Page 4

Browse online or download pdf Installation And Operation Manual for Recording Equipment American Time SiteSync IQ. American Time SiteSync IQ 7 pages. Wireless system controller with standard gps & magnetic mount tx antenna
Also for American Time SiteSync IQ: Quick Start Installation Manual (2 pages), Installation And Operation Manual (2 pages), Installation And Operation Manual (13 pages), Installation And Operation Manual (6 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Manual (2 pages), Quick Start Manual (2 pages), Quick Start Manual (2 pages)

Print Page

Specifications

Dimensions: ...............................10

Weight: ........................................4.8 lbs

Voltage Input: .............................120vac, 11 mA

Operating Temperature: .............41˚-131˚F (5˚-55˚C)

Termination: ................................Screw terminals

Receiver Specifications

Frequency: ..................................450-470MHz (factory set)

Paging Format: ...........................POCSAG, narrow band

Data Baud Rate: ..........................512 BPS

Sensitivity: ..................................10uV/M

Channel Spacing: ........................12.5 KHz

Tone Durations: ..........................1-9 seconds and one minute increments (set by the SiteSync

IQ® system controller)

Output Signal Specifications

Rated Output: ................ Adjustable from 0-1.15 volt P-P

Load Impedance: .......... 600 ohms or higher

Controls: ........................ Gain control - Screwdriver adjustment

Inputs: ........................... T1-T4 four dry contact inputs for tone selection. The Audio In input

allows normal background audio to play. Pre-empted by tone selection

Part # H004313

"h x 12

"w x 4"d

• Steady tones and Whoop last for the duration of the

contact input.

• Pulsed tones are 0.4 seconds ON and 0.4 seconds OFF

with a one second break before repeating.

• A two pulse tone repeats every 2.5 seconds for the

duration of contact input.

• A three pulse tone repeats every 3.25 seconds for the

duration of the contact input.

• The Chime sounds once when the contact is closed and

again when the contact is opened.

Wireless Tone Generator

inputs T1-T4.