Door-Gard 232iLM Installation & Programming Instructions - Page 2

Browse online or download pdf Installation & Programming Instructions for Intercom System Door-Gard 232iLM. Door-Gard 232iLM 8 pages. Keypad

Print Page

Keypad Installation Procedure:

Step 1: Drill through the back plate using a 11/64" bit. Use the template on the back page to accurately mark the mounting

holes before drilling. Then drill the mounting holes with a 9/64" drill bit. Also drill the hole for the wires. This may

vary depending on the number of conductors required.

Step 2: On the keypad end, strip back the insulator from the wire and tape the drain wire (shield) to the jacket. Now

connect the required wires to the 8-conductor wire harness provided. The wire harness plugs into the 8-position

connector on the keypad. At the other end of your wire run, strip back the insulator from the wire but do not tape

the drain wire to the jacket. The drain wire must be connected to ground at the controller end. See the diagrams

below.

Step 3: Finally mount the keypad onto the mounting surface using the provided screws. Do no over-tighten the screws,

which may result in damage.

Wiring the SSWiLM Keypad to a 232 Access Control Module

The connection between the SSWiLM Keypad and the 232 Controller requires a 4-conductor, stranded wire with overall

foil shield. The 8-conductor wire harness from the keypad connects to connector P6 on the controller. Connect the wires,

color to color (red to red, black to black, white/black to white/black and white/yellow to white/yellow). Refer to the wire

lengths on the ﬁ rst page. As mentioned above, the drain wire must be attached to Ground on the controller side, which is

the V- terminal or negative of your power supply.

232iLM Keypad Installation & Programming

6-050800 X2