Canon PIXMA MP495 Series Network Setup Manual - Page 10
Browse online or download pdf Network Setup Manual for All in One Printer Canon PIXMA MP495 Series. Canon PIXMA MP495 Series 24 pages. Cartridge reset
Also for Canon PIXMA MP495 Series: Installation Manual (22 pages), Network Manual (20 pages), Manual (8 pages), Network Setup Manual (9 pages), Manual (4 pages)
Print Page
- 1. Table of Contents
- 2. The Target Access Point Is Not Displayed (Detected) on the Detected Access Points
- 3. Set Printer Ip Address Screen Is Displayed
- 4. The Machine Is Not Displayed (Detected) on the Detected Printers List Screen
- 5. Problems During Network Setup
- 6. Configuring Wireless Lan Settings Manually
- 7. Other Troubleshooting Tips
- 8. Restoring the Machine's Default Lan Settings to Perform Setup Again
6-A
WEP
G
I
1
Enter the network key in WEP Key (F).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
5 or 13 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 10 or 26 characters (digits).
2
Select Key Length (G).
•
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select 128
bit.
3
Select Key Format (H).
•
Select ASCII when the network key is 5 or 13 characters.
Select Hex when it is 10 or 26 characters (digits).
4
Select Key ID (I).
•
When using AirPort, select 1 in the screen.
Selecting other key numbers will disable the connection between the machine and
AirPort.
5
Select Authentication (J), then click OK (K).
Go to .
WPA/WPA2
Disable
F
H
J
K
6-B
WPA/WPA2
L
1
Enter the network key in Passphrase (L).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
between 8 and 63 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 64 characters.
2
Select Dynamic Encryption Type (M), then click OK (N).
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select
AES(Secure Encryption).
•
When the access point is set to operate in IEEE802.11g and IEEE802.11n with TKIP,
communication is established using IEEE802.11g.
•
When the access point is set to operate only in IEEE802.11n with TKIP, a connection
cannot be established. Change the encryption type to something other than TKIP or
change the standard to something other than IEEE802.11n, then configure wireless
LAN settings again.
Go to .
7
The Manual Setup screen returns. Click Connect.
•
After that, follow the on-screen instructions to proceed with settings.
Disable
M
N