Cognex DataMan 475 Quick Reference Manual - Page 2

Browse online or download pdf Quick Reference Manual for Industrial Equipment Cognex DataMan 475. Cognex DataMan 475 18 pages. Verifier

Print Page

Precautions

To reduce the risk of injury or equipment damage, observe the following precautions

when you install the Cognex product:

The verifier is intended to be supplied by a UL or NRTL listed power supply

with a 24VDC output rated for at least 2A continuous and a maximum short

circuit current rating of less than 8A and a maximum power rating of less

than 100VA and marked Class 2 or Limited Power Source (LPS). Any other

voltage creates a risk of fire or shock and can damage the components.

Applicable national and local wiring standards and rules must be followed.

Route cables and wires away from high-current wiring or high-voltage

power sources to reduce the risk of damage or malfunction from the

following causes: over-voltage, line noise, electrostatic discharge (ESD),

power surges, or other irregularities in the power supply.

Do not install Cognex products where they are exposed to environmental

hazards such as excessive heat, dust, moisture, humidity, impact, vibration,

corrosive substances, flammable substances, or static electricity.

Do not expose the image sensor to laser light. Image sensors can be

damaged by direct, or reflected, laser light. If your application requires laser

light that might strike the image sensor, use a lens filter at the corresponding

laser wavelength. For suggestions, contact your local integrator or

application engineer.

Changes or modifications not expressly approved by the party responsible

for regulatory compliance could void the user's authority to operate the

equipment.

Include service loops with cable connections.