Cognex DataMan 475 Quick Reference Manual - Page 6

Browse online or download pdf Quick Reference Manual for Industrial Equipment Cognex DataMan 475. Cognex DataMan 475 18 pages. Verifier

Print Page

Mounting and Connecting the Verifier

CAUTION:

The Ethernet cable shield must be grounded at the far end.

Whatever this cable is plugged into (usually a switch or router) should have a

grounded Ethernet connector. A digital voltmeter should be used to validate

the grounding. If the far end device is not grounded, a ground wire should be

added in compliance with local electrical codes.

CAUTION:

To reduce emissions, connect the far end of the Breakout cable

shield to frame ground.

Perform the following steps:

1. Mount the verifier so that the distance from the bottom of the light housing to

the plane of the code is 60 mm.

Tip: Measure each corner of the light housing to 60 mm (+/- 3 mm).

2. Connect the Ethernet cable to a computer or a network switch.

3. Connect the breakout cable to a 24 V power supply.

For information on the cable pinout and wire colors, see section Connections, Optics,

and Lighting in the DataMan 475 Verifier Reference Manual.

Note:

Cables are sold separately.

If a standard component is missing or damaged, immediately contact

your Cognex Authorized Service Provider (ASP) or Cognex

Technical Support.