Astro Tool M22520/40-01 Assembly - Page 4

Browse online or download pdf Assembly for Crimp tool Astro Tool M22520/40-01. Astro Tool M22520/40-01 6 pages. For terminals, splices, and endcaps

Print Page

CONDUCTOR CAVITY

1. Close the tool handles fully, and hold

them firmly closed.

2. Insert the appropriately sized GO gage

(Green) member under the locator and

into the conductor cavity, of the die

(Red or Blue) you are trying to gage

(See Figure 2).

3. The GO gage member should freely enter

the die.

______________________________________________________________________________________________

TI4001

ASTRO TOOL CORP.

CONNECTOR ASSEMBLY TOOLING

GAGE MEMBER

CAUTION: DO NOT CRIMP THE GAGE MEMBER.

DOING SO MAY SERIOUSLY DAMAGE THE DIE SET!

21615 SW T-V Hwy, Beaverton, OR 97006 USA

Phone: 503-642-9853 Fax: 503-591-7766

4. Attempt to insert the NO-GO gage (Red)

member under the locator and into the

conductor cavity, of the die (Red or Blue)

you are trying to gage (See Figure 2).

5. The NO-GO gage (Red) member may

enter slightly into the die cavity, but should

not pass fully through the cavity. If the

NO-GO gage (Red) member does enter the

cavity fully, the die is worn and should be

replaced.

UPPER DIE

LOCATOR

LOWER DIE

FIGURE 2

Page 4 of 6

Astro Tool Corporation

REV. A

7-9-08