Canon BCTV KH13x4.5 KRSD SY14 Operation Manual - Page 4

Browse online or download pdf Operation Manual for Camera Lens Canon BCTV KH13x4.5 KRSD SY14. Canon BCTV KH13x4.5 KRSD SY14 6 pages.

Print Page

Canon BCTV KH13x4.5 KRSD SY14 Operation Manual

For KTS type lenses

Operation Using a Remote Controller

① Before Starting Remote Operation

Please purchase a remote controller, and extension cables if required. For built-in extender lenses, please

prepare an extender remote

controller and an extender control cable.

Remote Controller

　 TCR-101F　 Speed servo control type of zoom, focus, and iris

　TCR-201F　Position servo control type of zoom, focus, and iris

　TCR-301F　Dual control type of zoom, focus, and iris / Zooming and

focusing presets are possible up to 8 shots

② Connection and Setting

CO NT

③ Operation of Remote Controller

For the operating procedure, refer to the PDF Operation Manual in CD-Rom.

GENERAL SAFETY INFORMATION

The safety warnings and cautions provided on the product or in this operation manual must be observed. Failure to

observe these warnings and cautions provided to guard against hazards may result in injury or accident. Read this

operation manual carefully to familiarize yourself with its contents and ensure that you can operate the product properly.

Also, store this manual in a safe place where it can easily be referenced whenever required.

This operation manual uses the following symbols and terms to identify hazards to protect you and others by aiming to

prevent the occurrence of accidents.

This indicates a potentially hazardous situation which, if not heeded, may result in death or

WARNING

serious injury to you or others. Be sure to heed all warning notices to ensure safe operation

at all times.

Indicates hazardous situations which, if not heeded, may result in minor or moderate injury to

CAUTION

you or other persons, or damages to your property.

Emphasizes essential inform which, if not heeded, may render the product unworkable or

NOTE

cause it to function improperly. Also, provides helpful information for operation.

HANDLING THE PRODUCT

WARNING

1. Never allow water to enter or be spilled on the product. Immediately stop using the product if water enters the

product. Otherwise, a fire or electric shock hazard may result.

2. Do not stare at the sun or other source of high-intensity light through the lens. Doing so may result in injury to your eyes.

CAUTION

1. Do not drop the lens when transporting it or when attaching or detaching it to or from the camera head. The lens

may fall, possibly causing injury.

2. Make sure all mountings are tightened securely. If any of these mountings becomes loose, the lens may fall,

possibly causing injury.

3. Always grasp the connector itself when connecting or disconnecting the lens cable. Pulling on the cable portion

may result in damage to the cable, such as breakage of the conductors. Power leaking from a damaged cable may

present a fire or electric shock hazard.

4. Inspect all mountings periodically (about every 6 months to year) to make sure they are securely tightened, and

tighten any loose portions. Otherwise, the lens may fall, possibly causing injury.

5. If it becomes necessary to repair this product, or to perform any operations or adjustments not mentioned in this

operation manual, contact Canon's representative or the dealer who originally supplied lens.

NOTE

1. Protect the lens from strong impacts of shocks. Striking or dropping the lens may result in a malfunction.

2. This lens is not completely waterproof, so avoid exposing it directly to rain or snow. When the lens must be used in

rain or snow, provisions should be made to prevent the lens from getting wet.

3. Under dusty conditions, the lens should be mounted or dismounted with a cover placed over the mount so as to

prevent dust from entering into the interior.

4. Do not bring the lens, kept in a very cold ambient temperature, into a warm room, because the lens may fog on the

inside or condensation may occur.

In these cases, the lens cannot be used until these problems clear.

If the lens must be used under such conditions, countermeasures are recommended. (For instance, before bringing

the lens into a warm room, put it in a vinyl bag with an effective desiccant, and then bring it into the room. After the

temperature acclimatizes to the same level as the room temperature, take out the lens out of the vinyl bag.)

5. If the lens is to be used in adverse environments, such as in a chemical laden atmosphere, consult with Canon's

representative beforehand.

DEALING WITH ABNORMALITIES

WARNING

1. Should any of the abnormalities described below occur, immediately unplug the lens cable from the camera, and

then contact Canon's representative or the dealer from whom you purchased the lens.

・Smoke, abnormal smell, or abnormal noise.

・ Entry of foreign objects (including metals and liquids) inside the lens.

MAINTENANCE AND INSPECTION

WARNING

1. Unplug the lens cable and remove the lens from the camera, before attempting to clean the lens. Never use

flammable substances such as benzene or thinner for cleaning, as this may present a serious fire or electric shock

hazard.

Pub No. B-IM-20199F

Extension cable

　TCC-05 : 5m

　TCC-10 : 10m

　TCC-20 : 20m

　TCC-50 : 50m

　TCC-100 : 100m

① Control Cable

Connect to the remote controller.

② Power/Iris Control Cable

Connect to the camera.

③ Auto/Manual Focus Selecting Switch

Set to "A" position.

④ Auto/Manual Zoom Selecting Switch

Set to "A" position.

⑤ Auto/Manual Iris Selecting Switch

Set to "A" position.

MEMO

NOTE

1. Dust or fingerprints on the lens surface. Gently blow or brush away dust or dirt on the lens surface using a lens blower

or a soft lens brush. Remove any fingerprints or other stains with a clean cotton cloth moistened with commercially

available lens cleaning fluid or lens cleaning paper. Gently swirl the cloth or cleaning paper over the lens surface,

starting at the center area of the lens, and then circling gradually outward until whole lens surface has been covered. Be

careful not to rub dust across the lens, as the lens surface may be scratched.

2. A periodic inspection about once a year is recommended. The inspection and maintenance interval depends on the operating

conditions, the frequency of use, and the environment. If required, overhaul the lens.

CAUTION

1. Always attach the caps before storing the lens. Storing the lens without these caps attached may present a fire hazard.

(Very bright light, such as sunlight, may be focused by the lens and cause a fire.)

NOTE

1. If the lens becomes damp because of use in fog, mist or drizzle, wipe off the moisture with a soft dry cloth and seal the

lens together with an efficient desiccant in a vinyl bag to remove moisture which has entered into the interior.

1. Canon shall bear no responsibility for damage resulting from improper operation of this product by the customer.

2. Canon shall make no guarantees about the product quality, functions, or operation manual and its marketability and

suitability for the customer's purpose.

Moreover, Canon shall bear no responsibility for any damage, direct or incidental, that results from usage for the

customer's purpose.

3. Canon shall make no guarantees about the results obtained using this product.

4. The product specifications, configuration, and appearance are subject to change without prior notice.

5. For further information on repairs, maintenance, or adjustments not mentioned in this operation manual, contact your

Canon dealer or your Canon sales representative.

6. Note that Canon may be unable to undertake servicing or repair of a product if it is modified without consulting Canon or

your Canon sales representative.

We, Canon Inc., in Japan and CANON EUROPE LTD., in U.K., confirm that the BCTV zoom lens is in conformity with the es-

sential requirements of EC Directive(s) by applying the following standards:

EN55032 and EN55103-2

Note:

a) Applicable Electromagnetic Environments:

E1 (residential), E2 (commercial and light industrial), E3 (urban outdoors) and E4 (controlled EMC environment, ex. TV

studio).

b) Use of shielded cable is required to comply with limits specified by above standards.

Dieses Produkt ist zum Gebrauch im Wohnbereich, Geschäfts- und Gewerbebereich sowie in Kleinbetrieben vorgesehen.

Only for European Union and EEA (Norway, Iceland, and Liechtenstein)

This symbol indicates that this product is not to be disposed of with your household waste, according to the

WEEE Directive (2012/19/EU) and national legislation. This product should be handed over to a designated

collection point, e.g., on an authorized one-for-one basis when you buy a new similar product or to an

authorized collection site for recycling waste electrical and electronic equipment (EEE). Improper handling

of this type of waste could have a possible negative impact on the environment and human health due to

potentially hazardous substances that are generally associated with EEE. At the same time, your cooperation

in the correct disposal of this product will contribute to the effective usage of natural resources. For more

information about where you can drop off your waste equipment for recycling, please contact your local city

office, waste authority, approved WEEE scheme or your household waste disposal service.

For more information regarding return and recycling of WEEE products, please visit

www.canon-europe.com/weee.

CANON INC.

30-2, Shimomaruko 3-chome, Ohta-ku, Tokyo 146-8501, Japan

Canon Europe Ltd

3 The Square, Stockley Park, Uxbridge, Middlesex, UB11 1ET UK

STORAGE

TO THE CUSTOMER

may be reproduced or copied in any from or by any

means without the written permission of Canon Inc.

4/6