Canon BCTV KH13x4.5 KRSD SY14 Посібник з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Об'єктив камери Canon BCTV KH13x4.5 KRSD SY14. Canon BCTV KH13x4.5 KRSD SY14 6 сторінок.
![Canon BCTV KH13x4.5 KRSD SY14 Посібник з експлуатації](/uploads/products/server2/1168418/1168418.jpg)
For KTS type lenses
Operation Using a Remote Controller
① Before Starting Remote Operation
Please purchase a remote controller, and extension cables if required. For built-in extender lenses, please
prepare an extender remote
controller and an extender control cable.
Remote Controller
TCR-101F Speed servo control type of zoom, focus, and iris
TCR-201F Position servo control type of zoom, focus, and iris
TCR-301F Dual control type of zoom, focus, and iris / Zooming and
focusing presets are possible up to 8 shots
② Connection and Setting
CO NT
.
③ Operation of Remote Controller
For the operating procedure, refer to the PDF Operation Manual in CD-Rom.
GENERAL SAFETY INFORMATION
The safety warnings and cautions provided on the product or in this operation manual must be observed. Failure to
observe these warnings and cautions provided to guard against hazards may result in injury or accident. Read this
operation manual carefully to familiarize yourself with its contents and ensure that you can operate the product properly.
Also, store this manual in a safe place where it can easily be referenced whenever required.
This operation manual uses the following symbols and terms to identify hazards to protect you and others by aiming to
prevent the occurrence of accidents.
This indicates a potentially hazardous situation which, if not heeded, may result in death or
WARNING
serious injury to you or others. Be sure to heed all warning notices to ensure safe operation
at all times.
Indicates hazardous situations which, if not heeded, may result in minor or moderate injury to
CAUTION
you or other persons, or damages to your property.
Emphasizes essential inform which, if not heeded, may render the product unworkable or
NOTE
cause it to function improperly. Also, provides helpful information for operation.
HANDLING THE PRODUCT
WARNING
1. Never allow water to enter or be spilled on the product. Immediately stop using the product if water enters the
product. Otherwise, a fire or electric shock hazard may result.
2. Do not stare at the sun or other source of high-intensity light through the lens. Doing so may result in injury to your eyes.
CAUTION
1. Do not drop the lens when transporting it or when attaching or detaching it to or from the camera head. The lens
may fall, possibly causing injury.
2. Make sure all mountings are tightened securely. If any of these mountings becomes loose, the lens may fall,
possibly causing injury.
3. Always grasp the connector itself when connecting or disconnecting the lens cable. Pulling on the cable portion
may result in damage to the cable, such as breakage of the conductors. Power leaking from a damaged cable may
present a fire or electric shock hazard.
4. Inspect all mountings periodically (about every 6 months to year) to make sure they are securely tightened, and
tighten any loose portions. Otherwise, the lens may fall, possibly causing injury.
5. If it becomes necessary to repair this product, or to perform any operations or adjustments not mentioned in this
operation manual, contact Canon's representative or the dealer who originally supplied lens.
NOTE
1. Protect the lens from strong impacts of shocks. Striking or dropping the lens may result in a malfunction.
2. This lens is not completely waterproof, so avoid exposing it directly to rain or snow. When the lens must be used in
rain or snow, provisions should be made to prevent the lens from getting wet.
3. Under dusty conditions, the lens should be mounted or dismounted with a cover placed over the mount so as to
prevent dust from entering into the interior.
4. Do not bring the lens, kept in a very cold ambient temperature, into a warm room, because the lens may fog on the
inside or condensation may occur.
In these cases, the lens cannot be used until these problems clear.
If the lens must be used under such conditions, countermeasures are recommended. (For instance, before bringing
the lens into a warm room, put it in a vinyl bag with an effective desiccant, and then bring it into the room. After the
temperature acclimatizes to the same level as the room temperature, take out the lens out of the vinyl bag.)
5. If the lens is to be used in adverse environments, such as in a chemical laden atmosphere, consult with Canon's
representative beforehand.
DEALING WITH ABNORMALITIES
WARNING
1. Should any of the abnormalities described below occur, immediately unplug the lens cable from the camera, and
then contact Canon's representative or the dealer from whom you purchased the lens.
・Smoke, abnormal smell, or abnormal noise.
・ Entry of foreign objects (including metals and liquids) inside the lens.
MAINTENANCE AND INSPECTION
WARNING
1. Unplug the lens cable and remove the lens from the camera, before attempting to clean the lens. Never use
flammable substances such as benzene or thinner for cleaning, as this may present a serious fire or electric shock
hazard.
Pub No. B-IM-20199F
Extension cable
TCC-05 : 5m
TCC-10 : 10m
TCC-20 : 20m
TCC-50 : 50m
TCC-100 : 100m
① Control Cable
Connect to the remote controller.
② Power/Iris Control Cable
Connect to the camera.
③ Auto/Manual Focus Selecting Switch
Set to "A" position.
④ Auto/Manual Zoom Selecting Switch
Set to "A" position.
⑤ Auto/Manual Iris Selecting Switch
Set to "A" position.
MEMO
NOTE
1. Dust or fingerprints on the lens surface. Gently blow or brush away dust or dirt on the lens surface using a lens blower
or a soft lens brush. Remove any fingerprints or other stains with a clean cotton cloth moistened with commercially
available lens cleaning fluid or lens cleaning paper. Gently swirl the cloth or cleaning paper over the lens surface,
starting at the center area of the lens, and then circling gradually outward until whole lens surface has been covered. Be
careful not to rub dust across the lens, as the lens surface may be scratched.
2. A periodic inspection about once a year is recommended. The inspection and maintenance interval depends on the operating
conditions, the frequency of use, and the environment. If required, overhaul the lens.
CAUTION
1. Always attach the caps before storing the lens. Storing the lens without these caps attached may present a fire hazard.
(Very bright light, such as sunlight, may be focused by the lens and cause a fire.)
NOTE
1. If the lens becomes damp because of use in fog, mist or drizzle, wipe off the moisture with a soft dry cloth and seal the
lens together with an efficient desiccant in a vinyl bag to remove moisture which has entered into the interior.
1. Canon shall bear no responsibility for damage resulting from improper operation of this product by the customer.
2. Canon shall make no guarantees about the product quality, functions, or operation manual and its marketability and
suitability for the customer's purpose.
Moreover, Canon shall bear no responsibility for any damage, direct or incidental, that results from usage for the
customer's purpose.
3. Canon shall make no guarantees about the results obtained using this product.
4. The product specifications, configuration, and appearance are subject to change without prior notice.
5. For further information on repairs, maintenance, or adjustments not mentioned in this operation manual, contact your
Canon dealer or your Canon sales representative.
6. Note that Canon may be unable to undertake servicing or repair of a product if it is modified without consulting Canon or
your Canon sales representative.
We, Canon Inc., in Japan and CANON EUROPE LTD., in U.K., confirm that the BCTV zoom lens is in conformity with the es-
sential requirements of EC Directive(s) by applying the following standards:
EN55032 and EN55103-2
Note:
a) Applicable Electromagnetic Environments:
E1 (residential), E2 (commercial and light industrial), E3 (urban outdoors) and E4 (controlled EMC environment, ex. TV
studio).
b) Use of shielded cable is required to comply with limits specified by above standards.
Dieses Produkt ist zum Gebrauch im Wohnbereich, Geschäfts- und Gewerbebereich sowie in Kleinbetrieben vorgesehen.
Only for European Union and EEA (Norway, Iceland, and Liechtenstein)
This symbol indicates that this product is not to be disposed of with your household waste, according to the
WEEE Directive (2012/19/EU) and national legislation. This product should be handed over to a designated
collection point, e.g., on an authorized one-for-one basis when you buy a new similar product or to an
authorized collection site for recycling waste electrical and electronic equipment (EEE). Improper handling
of this type of waste could have a possible negative impact on the environment and human health due to
potentially hazardous substances that are generally associated with EEE. At the same time, your cooperation
in the correct disposal of this product will contribute to the effective usage of natural resources. For more
information about where you can drop off your waste equipment for recycling, please contact your local city
office, waste authority, approved WEEE scheme or your household waste disposal service.
For more information regarding return and recycling of WEEE products, please visit
www.canon-europe.com/weee.
CANON INC.
30-2, Shimomaruko 3-chome, Ohta-ku, Tokyo 146-8501, Japan
Canon Europe Ltd
3 The Square, Stockley Park, Uxbridge, Middlesex, UB11 1ET UK
© 2015.05 CANON INC.
STORAGE
TO THE CUSTOMER
All rights reserved. No part of this operation manual
may be reproduced or copied in any from or by any
means without the written permission of Canon Inc.
4/6