AIR GREAN AG-D210 User Manual - Page 6

Browse online or download pdf User Manual for Dehumidifier AIR GREAN AG-D210. AIR GREAN AG-D210 8 pages. Commercial grade portable dehumidifier

Print Page

OPERATION NOTICES

1. There is a 3 minute delay after machine has shut down

prior to next start up cycle.

2. When moving the machine, do not tip the machine for

over 45 degrees angle to avoid damaging the compressor.

3. The compressor gives out heat when it is operating, and

ambient temperature may rise 1-3 degrees.

4. The air inlet and outlet must be away from the wall at least

4 inches.

5. Working environment shall be closed tight to maximize

dehumidification effect.

6. Dust on the air publication filter mesh may impair its effect

or even cause failure. Please clear regularly. If there is dust in

the environment, it must be cleared once a week or once a

day. Pull down the front panel, clear the filter. Tap the filter

mesh slightly or eliminate the dust by vacuum cleaner or

place the filter in warm water and brush and then wash with

tap water and dry it. A clean filter will increase the unit's overall

efficiency.

7. There is a door at the front of the machine. Press the top of

the door, to open it automatically. Remove the water tube;

connect one end with water outlet to the water tank, and the

other end through the water drainage port of the left side of

machine.

8. Maximum length of the tube is 20'.

COMMON TROUBLESHOOTING

Issue

Dehumidifier is

not operating.

Dehumidifier is

operating, but does

not dehumidify

Water leak

Random noise

Causes

Unit is not plugged in

Power switch is not energized

Power failure

Fuse is melted

Dust accumulated in air purification filter mesh

Object blocking air inlet and outlet

The door or window is open

The machine is inclined

Water pipe is blocked

Dehumidifier is not placed solidly

Air outlet clogged

Solution

Connect the power cord

Energize the power

Check circuit breaker

Replace the fuse

Clear the filter mesh

Remove the blocking object

Close the door and window

Level the machine

Remove the blocking object

Stabilize unit

Clear the filter mesh