AIR GREAN AG-D210 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AIR GREAN AG-D210. AIR GREAN AG-D210 8 pagina's. Commercial grade portable dehumidifier
Pagina afdrukken
OPERATION NOTICES
1. There is a 3 minute delay after machine has shut down
prior to next start up cycle.
2. When moving the machine, do not tip the machine for
over 45 degrees angle to avoid damaging the compressor.
3. The compressor gives out heat when it is operating, and
ambient temperature may rise 1-3 degrees.
4. The air inlet and outlet must be away from the wall at least
4 inches.
5. Working environment shall be closed tight to maximize
dehumidification effect.
6. Dust on the air publication filter mesh may impair its effect
or even cause failure. Please clear regularly. If there is dust in
the environment, it must be cleared once a week or once a
day. Pull down the front panel, clear the filter. Tap the filter
mesh slightly or eliminate the dust by vacuum cleaner or
place the filter in warm water and brush and then wash with
tap water and dry it. A clean filter will increase the unit's overall
efficiency.
7. There is a door at the front of the machine. Press the top of
the door, to open it automatically. Remove the water tube;
connect one end with water outlet to the water tank, and the
other end through the water drainage port of the left side of
machine.
8. Maximum length of the tube is 20'.
COMMON TROUBLESHOOTING
Issue
Dehumidifier is
not operating.
Dehumidifier is
operating, but does
not dehumidify
Water leak
Random noise
Causes
Unit is not plugged in
Power switch is not energized
Power failure
Fuse is melted
Dust accumulated in air purification filter mesh
Object blocking air inlet and outlet
The door or window is open
The machine is inclined
Water pipe is blocked
Dehumidifier is not placed solidly
Air outlet clogged
5
Solution
Connect the power cord
Energize the power
Check circuit breaker
Replace the fuse
Clear the filter mesh
Remove the blocking object
Close the door and window
Level the machine
Remove the blocking object
Stabilize unit
Clear the filter mesh