DOREMIDI MIDI light box Instructions Manual - Page 5

Browse online or download pdf Instructions Manual for Controller DOREMIDI MIDI light box. DOREMIDI MIDI light box 7 pages.

Print Page
5.3. Setting Mode
Click the knob to the "Mode", and rotate the knob to select the "Follow/Normal/Ripple/All
Show/Bar" mode. "Follow" mode requires the MLT-10 to connect to the application software. Other
modes are used for MIDI performance. The following is a description of each mode.
Mode
USB:
Follow
USB:
Normal
USB:
Ripple
USB:
AllShow
USB:
Bar
(Notice:
1) The CC controller is a continuous controller, which is often used to control the effect of music in MIDI
performance.
2) The CC controller control is only valid in the "AllShow" and "Bar" modes. In these mode, if it is set to use the
CC controller to control the light strip, the note will have no effect.)
Display
Follow
Mode
Color
Normal
Mode
Color
Ripple
Mode
Color
AllShow
Mode
Color
Bar
Mode
Color
Description
When receiving a note sent by the software, the
light strip will light up according to the note.
According to the note, if the wrong key is
pressed, the light strip will light up in red.
In this mode, the color of the light cannot be set.
(Note: In this mode, you need to connect the software with
the follow-up function, such as POP Piano. If the software
does not have the follow-up function, the "Follow" mode
may not work.)
When receiving a note signal, the light strip will
light up according to the note.
The note velocity will control the brightness of the
light strip.
When a note signal is received, the light strip
expands in two directions according to the
position of the note.
When receiving the note/CC controller signal, the
light strip will be fully on.
Control the brightness of the light strip according
to the strength of the note/the value of the CC
controller.
When receiving the note/CC controller signal,,
the light strip will light up partially.
Control the number of lamp leads on according
to the strength of the note or the value of the CC
controller.