Dorma ES 100 Manual - Page 12
Browse online or download pdf Manual for Garage Door Opener Dorma ES 100. Dorma ES 100 14 pages.
Print Page
DORMA
•
Troubleshooting for concealed rod multipoint lock
Fault
Motor does not respond.
Key switch in posItion:
1. Sliding
panels are unlocked.
2. Sliding
panels move twice against
the upper stop and are then re.
locked.
LED
Fault
lights up.
Signal tone emitted.
Set program switch from
"AUTOMATIC"
"OFF".
to
1. Sliding
panels are unlocked.
2. Sliding
panels move
the upper stop and are then rc-
locked.
LED
Fault
lights up.
Signal tone emitted.
Key sWitch in "Locked"
1. Sliding
panels are locked.
2. Sliding
panels move twice against
the lower stop and are then
unlocked.
LED
Fault
lights up.
Signal tone emitted.
Key switch in position:
1. Lock remains unlocked
LED
Fault
lights up.
Signal tone emitted.
Fault cannot be cancelled
program switch.
Sliding
door no longer accepts any
opening
signal.
ES 901l00~
Possible cause
Fault
Manual unlocking
motor supply.
"Unlocked"
The "Unlocked"
been activated.
tWIce
against
position:
The "locked"
limit switch is not
being activated.
"Automatic"
using the
"OFF" connection
switch interrupted.
lock
has been pulled over the limit
switch by hand. The
control then receives a stop signal.
r?J
Operate the program switch in the
sequence:
"AUTOMATIC".
has interrupted
Check the continuity
17 to terminal
limit switch has not
Connect voltmeter
of the limit switch.
Initiate
closing cycle.
During the closing cycle, the
voltmeter
Or
Remove the cable connection
limit switch from the control unit.
Attach the multi meter and operate
the lock using the manual unlocking
mechanism.
During the closing cycle, the
multi meter display should show 0 11.
Adjust the limit switches.
Cancel fault signal by operating
program switch in the following
sequence:
"OFF" - "AUTOMATIC"
"AUTOMATIC"
"AUTOMATIC"
Connect voltmeter
switch.
Initiate
closing cycle.
During the closing cycle, the
voltmeter
Or
Remove the cable connection
limit switch from the control unit.
Attach the multimeter
the lock using the manual unlocking
mechanism.
During the closing cycle, the
multi meter display should show 0
Adjust the limit switches.
Cancel fault signal by operating
program switch in the following
sequence:
"OfF"
- "AUTOMATIC"
"AUTOMATIC"
"AUTOMATIC"
of the program
Check connection
a reset (remove plugs 11112/13
the ES9Q control unit and then re-
insert after approx. 2 seconds).
Move the lock using the manual
ES901l00
unlocking
end position
into its end position
switch.
~
DORMA
Remedy
"AUTOMATIC"
- "OFF" -
from terminal
20.
to the terminals
display must show OV.
for the
the
or
. "OFF".
to the limit
display must show OV.
for the
and operate
u.
the
or
- "OFF
Il
•
at pin 5. Perform
from
mechanism
back to its
or operate the lock back
using the key