Cansec H1000 Installation Manual - Page 12
Browse online or download pdf Installation Manual for Controller Cansec H1000. Cansec H1000 20 pages. Elevator control
Print PageMASTER PANEL COMMUNICATION LEDS
Host Communication LEDs
The Master H1000 control panel uses two LEDs to indicate Host communication. One
LED indicates Transmit (TX) and the other LED indicates Receive (RX). The LEDs are
labeled RS-485 TX (Green LED2) and RX (Red LED3). If Host communication is
present these LEDs toggle on and off. See location below on the H1000 panel.
Master EX100 Communication LEDs
If the Master H1000 panel has been correctly configured as a 32 to 64 floor elevator
system, the two LEDs on the EX100 daughter board will indicate the RS485
communication to the Slave H1000 control panels. The EX100 LEDs are labeled
TX485 (Green LED1) and RX485 (Red LED2). If no Slave H1000 panels are
connected to the Master H1000 control panel, the TX485 (Green LED1) will toggle
On and Off. If all the H1000 Slave control panels are configured and connected
correctly, both TX485 (Green LED1) and RX485 (RED LED2) will toggle On and Off.
RX485 LED
Transmit (TX) LED
TX485 LED
H1000 Elevator Control
Installation Guide
Receive (RX) LED
RS485 Host Communication
October 2015 • Rev. 1.7
Page 12 of 20