Cansec H1000 Manual de instalação - Página 12

Procurar online ou descarregar pdf Manual de instalação para Controlador Cansec H1000. Cansec H1000 20 páginas. Elevator control

MASTER PANEL COMMUNICATION LEDS

 Host Communication LEDs

The Master H1000 control panel uses two LEDs to indicate Host communication. One

LED indicates Transmit (TX) and the other LED indicates Receive (RX). The LEDs are

labeled RS-485 TX (Green LED2) and RX (Red LED3). If Host communication is

present these LEDs toggle on and off. See location below on the H1000 panel.

 Master EX100 Communication LEDs

If the Master H1000 panel has been correctly configured as a 32 to 64 floor elevator

system, the two LEDs on the EX100 daughter board will indicate the RS485

communication to the Slave H1000 control panels. The EX100 LEDs are labeled

TX485 (Green LED1) and RX485 (Red LED2). If no Slave H1000 panels are

connected to the Master H1000 control panel, the TX485 (Green LED1) will toggle

On and Off. If all the H1000 Slave control panels are configured and connected

correctly, both TX485 (Green LED1) and RX485 (RED LED2) will toggle On and Off.

RX485 LED

Transmit (TX) LED

TX485 LED

H1000 Elevator Control

Installation Guide

Receive (RX) LED

RS485 Host Communication

October 2015 • Rev. 1.7

Page 12 of 20