Cansec P-640-HA37 Installation Instructions Manual - Page 8
Browse online or download pdf Installation Instructions Manual for Card Reader Cansec P-640-HA37. Cansec P-640-HA37 14 pages. Canprox proximity/keypad reader
Print Page
- 1. Table of Contents
- 2. Specifications
- 3. Introduction
- 4. Wall Mounting
- 5. Wiring - Cansec Controllers
- 6. Wiring - 3 Rd Party Controllers
- 7. Programming
- 7. P-640-HA & P-620-HA (26-Bit Wiegand Output)
- 7. P-640-HA37 & P-620-HA37 (Cansec 37-Bit Wiegand Output)
- 8. Proximity/Keypad Reader Usage
- 9. Card + PIN Interface Module - Optional
- 9. Card + PIN Usage
- 10. Reader/Keypad Troubleshooting
- 11. Appendix
Programming
P-640-HA & P-620-HA (26-BIT WIEGAND OUTPUT) – APPLICABLE FOR
3RD PARTY AND CANSEC CONTROLLERS
The reader is shipped with the keypad outputting 8-bit burst Wiegand. To change
the keypad output to 26-bit Wiegand, follow the procedure below.
8-bit burst mode
1. Cycle power to the reader.
2. Present the Wiegand Keypad Data Mode control card to the reader – reader will
beep four times.
3. Enter the facility code to be applied to the keypad (FC = 0 to 255); the default
facility code is usually 0. If an unacceptable facility code is entered the reader will
give out one long beep.
4. Press the "#" key - reader will beep four times to indicate success.
5. Press the "*" key – reader should beep four times to indicate 26-bit mode is
enabled.
P-640-HA37 & P-620-HA37 (CANSEC 37-BIT WIEGAND OUTPUT) –
APPLICABLE FOR CANSEC CONTROLLERS ONLY
The reader is shipped with the keypad outputting 8-bit burst Wiegand. To change
the keypad output to Cansec 37-bit Wiegand, follow the procedure below.
Appendix for 8-bit burst mode
1. Cycle power to the reader.
2. Present the Wiegand Keypad Data Mode control card to the reader – reader will
beep four times.
3. Enter the facility code to be applied to the keypad (FC = 0 to 32767); the default
facility code is usually 0. If an unacceptable facility code is entered the reader will
give out one long beep.
4. Press the "#" key – reader will beep four times to indicate success.
5. Press the "*" key – reader should beep four times to indicate 37-bit mode is
enabled.
.
.
CanProx Proximity/Keypad Reader
Installation Instructions
See Appendix for
See
Page 8 of 14
August 2018 • Rev. 1.6