Cansec P-640-HA37 Installation Instructions Manual - Page 9
Browse online or download pdf Installation Instructions Manual for Card Reader Cansec P-640-HA37. Cansec P-640-HA37 14 pages. Canprox proximity/keypad reader
Print Page
- 1. Table of Contents
- 2. Specifications
- 3. Introduction
- 4. Wall Mounting
- 5. Wiring - Cansec Controllers
- 6. Wiring - 3 Rd Party Controllers
- 7. Programming
- 7. P-640-HA & P-620-HA (26-Bit Wiegand Output)
- 7. P-640-HA37 & P-620-HA37 (Cansec 37-Bit Wiegand Output)
- 8. Proximity/Keypad Reader Usage
- 9. Card + PIN Interface Module - Optional
- 9. Card + PIN Usage
- 10. Reader/Keypad Troubleshooting
- 11. Appendix
CONFIGURATION CARD FOR CANSEC H1000 AND MAP1 OR MAP2
CONTROLLERS
The following is a sample of one of the 4-bit burst configuration cards, which when
presented to the P-640-HA, P-620-HA or P-640-HA37, P-620-HA37 reader will
enable it to use 4-bit burst in keypad mode. This configuration is only required
when using the "Keypad Options" modes available in Hurricane software (Card
only, Card plus PIN and PIN only) or "Card + PIN", "Card + PIN or Keypad Card
ID" options in First Access software.
See "H1000 Integrated Keypad Installation Guide" for detailed installation and
configuration instructions for H1000.
Proximity/Keypad Reader Usage
Keypad usage: enter a PIN number between 1 and 65534 follow by "#"
Reader usage: present a compatible proximity credential to the reader
NOTE: Keypad and reader modes are both enabled and cannot be toggled. This
allows the usage for both card users and PIN users.
CanProx Proximity/Keypad Reader
Installation Instructions
4-Bit Burst Label
Page 9 of 14
August 2018 • Rev. 1.6